Advertisement
Press "Select" to enter the Inner Fan full speed temperature setting. When
are on press + or - to enter parameters settings. LCD will show the full speed point temperature.
Setting range is 93°F to 140°F (34 to 60 ). The Enclosure Fan will reach High speed at the
temperature setting.
9. Enclosure Fan speed regulation point temperature setting (Default set to 86°F)
Press "Select" to enter the Inner Fan speed regulation point temperature setting. When
+
+
speed regulation point temperature. Setting range is 60°F to 95°F (15 to 35 ). The fan speed will
begin to increase at this temperature setting.
10. Enclosure Fan starting point temperature setting (Default set to -4°F)
NOTE: this default has been set so that the Inner Fans run at low speed all the time unless temperature
is met inside the enclosure.
Press "Select" to enter the Inner Fan starting point temperature setting. When
+
+
point temperature. Setting range is -4°F to 68°F (-20 to 20 ). The set temperature must be lower
than or the same with the speed regulation point temperature of inner fan.
11. Outside Fan full speed temperature setting (Default set to 108°F)
Press "Select" to enter the Outside Fan full speed temperature setting.
When
+
+
full speed point temperature. Setting range is 93°F to 140°F (34 to 60 ). The Outside Fan will reach
High speed at this temperature setting.
12. Outside Fan speed regulation point temperature setting (Default set to 90°F)
Press "Select" to enter the Outside Fan speed regulation point temperature setting. When
+
+
speed regulation point temperature. Setting range is 86°F to 104°F (30 to 40 ). The Outside Fan
speed will begin to increase at this temperature setting.
13. Outside Fan starting point temperature setting (Default set to 86°F)
Press "Select" to enter the Outside Fan starting point temperature setting. When
+
+
point temperature. Setting range is 77°F to 86°F (25 to 30 ). The set temperature must be lower
than or the same with the speed regulation point temperature of outside fan.
14. Outside Fan temperature difference inside and outside of starting point (Default set to 4°F
Difference)
8-15-REV1
+
+
is on press + or - to enter parameters settings. LCD will show the
+
are on press + or - to enter parameters settings. LCD will show the starting
+
are on press + or - to enter parameters settings. LCD will show the
+
+
are on press + or - to enter parameters settings. LCD will show the
+
are on press + or - to enter parameters settings. LCD will show the starting
IMPORTANT: DO NOT CHANGE SETTING.
4
+
+
+
Advertisement
