Electrolux ERT13300WK User Manual page 4

4 electrolux
• This product should be serviced by an
authorized Service Center, and only genuine
spare parts should be used.
• Under no circumstances should you attempt
to repair the appliance yourself. Repairs carried
out by inexperienced persons may cause
injury or more serious malfunctioning. Refer to
your local Service Centre, and always insist on
genuine spare parts.
• This appliance contains hydrocarbons in its
cooling unit; maintenance and recharging
must therefore only be carried out by
authorized technicians.
Use
• The domestic wine refrigerator is designed to
be used specifically for the storage of potable
wine only.
• Best performance is obtained with ambient
temperature as follows:
Climate class
SN
N
ST
T
The class of your appliance is shown on its
rating plate.
• Warning: when the ambient temperature
is not included within the range indicated
for the class of this appliance, the following
instructions must be observed: when
the ambient temperature rises up the
maximum level, the storage temperature in
the refrigerator cannot be guaranteed, it is
advisable to use the food stored as soon as
possible.
• Do not put hot pot on the plastic parts of the
appliance.
• Do not store flammable gas and liquid in the
appliance, because they may explode.
• Do not place wine directly against the real wall
of compartment.
• The appliance's manufactures storage
recommendations should be strictly adhered
to. Refer to relevant instructions.
Ambient temperature
+10 °C to +32 °C
+16 °C to +32 °C
+16 °C to +38 °C
+16 °C to +43 °C
• The inner lining of the appliance consists
channels through which the refrigerant
passes. If these should be punctured this
would damage the appliance beyond repair
and cause food loss. DO NOT USE SHARP
INSTRUMENTS to scrape of frost or ice. Frost
may be removed by using a scraper. Under no
circumstances should be solid ice be forced off
the liner. Solid ice should be allowed to thaw
when defrosting the appliance.
Installation
Important: For electrical connection carefully
follow the instructions given in specific
paragraphs.
• Unpack the appliance and check if there are
damages on it. Do not connect the appliance
if it is damaged. Report possible damages
immediately to the place you bought it. In that
case retain packing.
• During normal operation, the compressor and/
or condenser at the back of the appliance
heat up considerably. For safety reasons,
minimum ventilation must be as shown in the
instructions.
Attention: keep ventilation openings clear
of obstruction.
• Care must be taken to ensure that the
appliance does not stand on the electrical
supply cable.
Important: if the supply cord is damaged, it
must be replaced by a special cord or assembly
available from the manufacture or its service
agent.
• If the appliance is transported horizontally,
it is possible that the oil contained in the
compressor flows in the refrigerant circuit. It
is advisable to wait at least two hours before
connecting the appliance to allow the oil to
flow back in the compressor.
• There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result
in component failure and possible loss. See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product
should be against a wall.