Cutting Height Adjustment; Roller Bar Adjustment; Neutral Adjustments - Snapper 18HP, 19HP Operator's Manual

Troubleshooting, Adjustments, & Service

CUTTING HEIGHT ADJUSTMENT

The cutting height adjustment pin (A, Figure 22) controls
the mower cutting height. The cutting height is
adjustable between 1-1/2" (3,8 cm) and 4-1/2" (11,4cm).
Pulling the lever back fully locks the control in transport
position.
To adjust cutting height:
1. Pull the adjustment lever (B, Figure 22) back fully
until it locks in transport position.
2. Remove the cutting height adjustment pin (A) and
insert it into the desired hole.
3. Pull back on the adjustment lever (B), squeeze the
smaller transport release lever (C), and allow the
lever to move forward until it is supported by the cut-
ting height adjustment pin (A).

ROLLER BAR ADJUSTMENT

The rollers on this Zero Turn unit are not intended to ride
on the ground. DO NOT adjust rollers to ride on the
ground. Rollers riding on the ground will damage turf and
or unit.
NEUTRAL ADJUSTMENT
If the unit creeps forward or backward with the control
levers in their neutral positions, see your dealer.
Figure 22. Cutting Height Adjustment
A. Cutting Height Adjustment Pin
B. Deck Lift / Cutting Height Lever
C. Transport Release Lever
24
C
B
A