Siemens SIMATIC NET 12M Operating Instructions Manual page 24

Approvals
EMC directive (electromagnetic compatibility)
The SIMATIC NET products described in these operating instructions meet the requirements
of EC directive 2004/108/EC "Electromagnetic Compatibility" for the following areas of
application:
Field of application
Industry
Personal injury and property damage can occur
The installation of expansions that are not approved for SIMATIC NET products or their
target systems may violate the requirements and regulations for safety and electromagnetic
compatibility.
Only use expansions that are approved for the system.
● Keep to the installation guidelines
The product meets the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation when
installing and operating the product.
● You can always find the latest documentation on the Internet
The current descriptions of the currently available products can always be found on the
Internet under the specified entry IDs/Internet pages:
– SIMATIC NET Industrial Ethernet Network manual
– EMC Installation Guideline, Planning Guide
– Working on the product
C-TICK
The product meets the requirements of the AS/NZS 2064 standard (Class A).
24
WARNING
ID = 27069465 (http://support.automation.siemens.com/WW/view/en/27069465)
ID = 60612658 (http://support.automation.siemens.com/WW/view/en/60612658)
To protect the product from electrostatic discharge, personnel must first discharge any
electrostatic charge from their body before touching the product.
Note
The product was tested with a device that also complies with the standards listed
above.
If the product is operated with a device that does not meet these standards, there is
no guarantee that the corresponding values will be adhered to.
Emission
EN 61000-6-4 : 2007
Operating Instructions, 07/2013, C79000-G8976-C333-01
Requirements
Immunity to interference
EN 61000-6-2 : 2005
12M bus terminal