Advertisement
A
WARNING
Before installing the kit or making any adjustments:
disengage the PTO; set the parking brake; stop the
engine and remove the key.
A
WARNING
When disconnecting the battery cables, always
disconnect the negative cable first. W h e n
connecting cables, always connect the negative
cable last. The positive terminal can easily be
shorted to the frame with a tool if this is not done.
Do not touch any wires or electrical components
such as the solenoid, unless the battery cables are
INSTALLATION
1. Park tractor on flat, level surface. Turn tractor off.
Disengage PTO, and allow all moving parts to stop.
Engage the parking brake.
from terminals.
gasoline may ignite. Insure clamps grip hose firmly
A
WARNING
Handle gasoline with care. It is highly flammable.
Use an approved gasoline container.
3. Drain the fuel tank as follows.
a. Place an approved gasoline container below the
fuel filter.
b. Use a pliers to spread the fuel filter clamps and
slide away from filter. Do not spread more than
necessary.
into container.
4. Raise rear right-hand side of tractor up and place
Remove rear right-hand wheel assembly.
Remove tive capscrews
secure kit hub assembly (0, figure 1) to wheel. Do not
install on tractor.
Prepare template (provided on last page) by cutting
out all dashed areas. Use this template to drill five
1 l/32" holes in wrapper.
Install rear actuator bracket (X, figure 1 or A, figure
2) with two capscrews (T, figure l), spacers (U),
lockwashers (D), and nuts (R). Install bolts from
outside in, putting spacers between bracket and
wrapper. Lockwashers and nuts are installed on
inside of wrapper. Do not install the 4-I /2"capscrew
(W) at this time.
9. Install front bracket (C, figure 2) with bottom
,
Secure with lockwasher (D, figure 1) and nut (R).
Figure 2. Bracket Installation
C. Front Bracket
10. Insert cylinder (A, figure 3) through brackets as
shown in figure 3. Makesurelugs(B)fit
rear bracket slots.
1 1 . Install top 4-l /2" capscrew (C) on rear bracket (with
spacer between bracket and wrapper) and secure
with locknut (V, figure I). Install top l"capscrew(D,
secure with lockwasher and nut.
from wheel assembly and
securely into
Advertisement
