Home Screen; Figure 5 - Home Screen - York OPTIVIEW Operation Manual

SECTION 2 - OPTIVIEW CONTROL CENTER INTRODUCTION

FIGURE 5 - HOME SCREEN

OVERVIEW
When the chiller system is powered on, the above de-
fault display appears. The primary values which must
be monitored and controlled are shown on this screen.
The Home Screen display depicts a visual representa-
tion of the chiller itself. Animation indicates chilled
liquid flow and/or condenser cooling liquid flow.
DISPLAY ONLY
Chilled Liquid Temperature - Leaving
Displays the temperature of the liquid as it leaves the
evaporator.
Chilled Liquid Temperature - Entering
Displays the temperature of the liquid as it enters the
evaporator.
Condenser Liquid Temperature - Leaving
Displays the temperature of the liquid as it leaves the
condenser.
Condenser Liquid Temperature - Entering
Displays the temperature of the liquid as it enters the
condenser.
18

HOME SCREEN

Input % Full Load Amps
This displays the percentage of full load amps utilized
by the system.
Input Power (kW)
This displays the total input power used by the
system.
Operating Hours
Displays the cumulative operating hours of the chiller.
Motor Run (LED)
Is ON when the digital output controlling the VSD
contact is on.
PROGRAMMABLE
Login
Access Level Required: VIEW
The OptiView Panel restricts certain operations based
on password entry by the operator. Three different ac-
cess levels are provided as follows: VIEW: The panel
defaults to the lowest access level which is termed
VIEW. In this mode, the chiller operating values and
setpoints can be observed, but no changes can be made.
OPERATOR: The second access level is termed OP‑
FORM 160.78-O2
ISSUE DATE: 5/22/2017
LD14844c
JOHNSON CONTROLS