Wolf VACUUM SEAL DRAWER Installation Manual page 6

IN S TA L L AT I O N
Preparation
Remove and recycle packing materials. Do not discard the
package containing the two screws provided for installation.
Install an anti-tip block against the rear cabinet wall. Verify
the screws are adequately secured and do not penetrate
electrical wiring or plumbing.
IMPORTANT NOTE: The installation hardware is provided
with the accessory front panel.
Installation
Place the unit on a protected work surface.
1
Slide the filter cover to the side and remove the plug.
2
Refer to the illustration below.
Insert the filter and rotate clockwise. Refer to the illustra-
3
tion below.
PLUG
Plug removal
|
6 Wolf Customer Care 800.222.7820
FILTER
Filter installation
Slide the cover over the filter.
4
Place the plug on the back of unit and remove the two
5
shipping screws. Refer to the illustration below.
Install the side trim. Refer to the installation instructions
6
provided with the accessory front panel.
Place the unit near the opening and plug the power cord
7
into the receptacle.
Slide the unit into the opening.
8
Open the drawer to full extension.
9
Drill a pilot hole in each mounting hole location. Refer
10
to the illustration below.
Secure the unit with the screws provided.
11
Turn on the electrical supply to the outlet and verify
12
operation.
SHIPPING
SCREWS
Shipping screw location
MOUNTING
HOLE
Mounting hole location