Interior Lighting; Alarm Off Button; Prior To Initial Start-Up; Initial Start-Up - AEG SANTO Series Operating Instructions Manual

Hide thumbs Also See for SANTO Series:

Table of Contents

Interior lighting

5 minutes. To expose the wine to the light as little as possible, the

interior light should only remain on for a short time.

Before connecting the appliance to the mains and putting it into ope-

ration for the first time, leave the appliance to stand for 30 minutes if

was transported upright. After transport on its side, the appliance must

be left to stand for 4 hours before putting it into operation. This is

necessary to allow the oil to flow back into the compressor. Otherwise

the compressor may be damaged.

1. Please clean the appliance interior and all accessories prior to initial

start-up (see section: "Maintenance and Cleaning").

2. The appliance must be correctly installed in accordance with the chap-

ter "Installation" before it is put into operation for the first time. Care

should be especially taken that the mains voltage and frequency avail-

able correspond with the appliance's rating plate.

1. Insert plug into mains socket.

2. Press ON/OFF button.

The compressor starts and then runs automatically.

3. Set the temperature (see section: "Temperature Adjustment").

Using this button the interior light can be switched on when

the door is closed. This means the contents of the wine

cooler can be checked over without having to open the door.

The interior light automatically switches itself off after

With the ALARM OFF button, the acoustic warning signal can

be switched off, e.g. the "Open Door" warning when sorting

in or out, the commodities to be chilled.

818 36 92-01/4

Table of Contents