Quick 2 Net; End A Data Session; Automatic Data Call Disconnection - Panasonic CF-18 Series Supplementary Instructions Manual

Note: You cannot establish a
data connection if a voice call is
active. You must first end the
voice call.
Rev 0.21 Dec.04

Quick 2 Net

Subject to feature availability.
Quick 2 Net (QNC) uses a circuit switched method to connect
to the Internet. The connection is slower (maximum speed of
14.4 kbps) than a VZAccess (NationalAccess or Broadban-
dAccess) packet data connection.
Quick 2 Net can be used when you have CDMA coverage but
not VZAccess (NationalAccess
service. This connection is treated like a standard phone call.
You can set the modem to automatically disconnect an idle
Quick 2 Net connection.
To make a Quick 2 Net connection:
Data
1. Select the tab
2. From the drop-down menu, select
Quick 2 NetSM (14.4kbps)
"
Connect
3. Click .
The connection progress is displayed in the Call status area.
Quick 2 Net calls connect faster than standard dial-up connec-
tions.
Related Topics:
>>|

End a data session

>>| Default data profile
>>|

Automatic data call disconnection

End a data session
To end a data session:
Data
• From the tab
Cancel
(during the connection process)
If Always-on connection is in use, manually disconnecting will
leave the EM5625 disconnected. It will not reconnect until one
of the following occurs:
• You make a VZAccess (NationalAccess or Broadban-
dAccess) high-speed packet data connection
• Watcher is restarted
Automatic data call disconnection
Subject to feature availability.
You can set Watcher to automatically disconnect dial-up and
Quick 2 Net data calls that have been inactive (no data trans-
mitted) for a specified period of time.
Data Services
or BroadbandAccess
of Watcher.
".
Disconnect
, select (if connected) or
)
31