Zte ZXSDR RSUC User Manual page 25

Name
DO MAC inactive channel
code domain power
DO DATA channel code
domain power
Wave quality of DO
channels
Radio frequency Front
End SWR
Table 7 illustrates the 800 MHz receiver indices.
T 7 800 MH R
ABLE Z ECEIVER
Name
Operating band
Receiver sensitivity
Receiver dynamic range
Noise figure
Single tone desensitiza-
tion
Intermodulation
spurious response
attenuation
Conducted spurious
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 Technical Descripition
Index
With configuration of 13 FLUSs, the MAC
inactive channel code domain power is less
than -29.5 dB (type 2).
With configuration of 13 FLUSs at the rate
of 614.44 kbs (test 1), the DATA channel
code domain power is in the range of -15.5
dB to -14.5 dB.
Pilot channel: Rho > 0.97
MAC channel: Rho > 0.912
DATA channel: Rho > 0.97
< 2.0
I
NDICES
Index
800 MHz (Band Class 0)
< -115 dBm
When the lower limit is the receiver
sensitivity and the upper limit (noise level)
equals 55 dBm/1.23MHz (Eb/N0 = 10
dB±1dB), the Frame Error Rate (FER) is
lower than 1%.
< 3
In the presence of a single tone that is
50 dB above the CDMA signal level, and
is at offset of ±750 kHz from the center
frequency, the output power of the MS
increases by no more than 3 dB ,and the
FER is less than 1.5%.
In the presence of a single tone that is
75 dB above the CDMA signal level, and
is at offset of ±900 kHz from the center
frequency, the output power of the MS
increases by no more than 3 dB, and the
FER is less than 1.5%.
BAND 0:
In the presence of two interfering tones
that are 60 dB above the CDMA signal level,
and are at offsets of +900 kHz, +1.7 MHz,
-900 kHz and -1.7 MHz from the center
frequency, the output power of the MS
increases by no more than 3 dB, and the
FER is less than 1.5%.
< -80 dBm, measured within the BTS
19