MSI MS-7293 Series Getting Started page 33

S3 HDD Security FreezeLock
This field allows you to enable or disable the HDD security in S3.
MPS Table Version
This field allows you to select which MPS (Multi-Processor Specification) version to
be used for the operating system. You need to select the MPS version supported by
your operating system. To find out which version to use, consult the vendor of your
operating system.
Full Screen LOGO Display
This item enables you to show the company logo on the bootup screen. Settings are:
[Enabled]
[Disabled]
CPU Feature
Press <Enter> to enter the sub-menu:
Limit CPUID MaxVal
The item allows you to enable/ disable the CPU ID maximum value.
[Enabled] Set to [Enabled] only when you have Prescott CPU and NT4.0
operating system.
[Disabled] Set to [Disabled] if you have operating system other than NT4.0.
C1E Function
W hen the C1E Support (Enhanced Halt Powerdown State) is enabled, the proc-
essor will transition to a lower core to bus ratio and lower voltage ID driven by
the processor to the voltage regulator before entering Halt Powerdown State
(C1). Not all porcessors support Enhanced Halt Powerdown State (C1E). You
can enable C1E Support to lower the CPU power consumption while idle.
Execute Disable Bit
Excute Bit Support function is designed for memory buffer overflow protection,
it can prevent viruses from proliferating.
Virtualization Technology
It allows you to enable or disable the Virtualzation Technology.
Hard Disk Boot Priority
Press <Enter> to enter the sub-menu and set the sequency of boot hard disk.
Boot Sequence
Press <Enter> to enter the sub-menu:
1st/2nd/3rd Boot Device
The items allow you to set the sequence of boot devices where BIOS attempts
to load the disk operating system.
Shows a still image (logo) on the full screen at boot.
Shows the POST messages at boot.
BIOS Setup
3-9