Download Print this page

Ultra Start 2500 Installation Manual page 10

Advanced remote vehicle starter & alarm
Hide thumbs Also See for 2500:

Advertisement

PROGRAM MODE - STARTER SETTINGS
Enter Starter Program Mode - See Page 7 for details on entering program mode
Setting 1- Special Door Lock/ Unlock Operations
1
Chrysler / VW Re-Arm
2
GM Auto Re-Lock
3*
Normal Operation
Press the Program Button 1 time to select setting 1 (This will be confirmed by 1 LED flash)
Press and hold the Program Button until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button. Press momentarily to move to next program step or repeat to change selection.
Setting 2- Gas/ Diesel Mode- Blue Wire on 14-Pin
1
Diesel Glow Plug
2
Timed Delay
3*
Gas Mode operation
Press the Program Button 2 times to select setting 2 (This will be confirmed by 2 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button. Press momentarily to move to next program step or repeat to change selection.
Setting 3- Rearm Output- Yellow Wire on 14-Pin
1
Type 1
2
Type 2
3*
Factory Re-arm
Press the Program Button 3 times to select setting 3 (This will be confirmed by 3 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button. Press momentarily to move to next program step or repeat to change selection.
Setting 4- Run Time
1
30 Min Run Time
2
45 Min Run Time
3*
15 Min Run Time
Press the Program Button 4 times to select setting 4 (This will be confirmed by 4 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button. Press momentarily to move to next program step or repeat to change selection.
Setting 5-Maximum Crank Time
1
10 Seconds
2
3 Seconds
3*
5 seconds
Press the Program Button 5 times to select setting 5 (This will be confirmed by 5 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button. Press momentarily to move to next program step or repeat to change selection.
Setting 6- Sensor Disconnect
1 Positive Input To Start
2 Positive Disconnect
3* Positive Disconnect
Press the Program Button 6 times to select setting 6 (This will be confirmed by 6 LED flashes)
Press and hold the Program Button until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Button. Press momentarily to move to next program step or repeat to change selection.
Setting 7- Sensor Disconnect
1 Positive Input To Start
2 Positive Disconnect
3* Positive Disconnect
Press the Program Switch 7 times to select setting 7 (This will be confirmed by 7 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes and siren chirps..
10
Release the Program Switch. Press the Program momentarily to move to next program step or repeat to change selection.
1 Flash
2 Flashes
3 Flashes
1 Flash
2 Flashes
3 Flashes
1 Flash
2 Flashes
3 Flashes
1 Flash
2 Flashes
3 Flashes
1 Flash
2 Flashes
3 Flashes
1 Flash
Positive pulse will activate remote starter.
2 Flashes
Alarm will trigger if disconnected from 12 volts.(Same as below)
3 Flashes
Alarm will trigger if disconnected from 12 volts.
1 Flash
Positive pulse will activate remote starter.
2 Flashes
Alarm will trigger if disconnected from 12 volts.(Same as below)
3 Flashes
Alarm will trigger if disconnected from 12 volts.
Installation Guide
Unlock pulse before start and a lock pulse after start
Lock pulse after remote starter shuts off
No additional re-lock pulses
W
aits a Maximum of 3:20 second before starting.
Ignition ON for 10 seconds before engaging remote starter
Waits 2 seconds before engaging starter output
Pulse after start and with lock
Pulse after start only
0.75 second pulse with lock and after shutdown
Remote Starter runs for 30min when activated
Remote Starter runs for 45min when activated
Remote Starter runs for 15 min when activated
10 sec Max time that starter will stay engaged
3 sec Max time that starter will stay engaged
5 sec Max time that starter will stay engaged
Continued on next page...

Advertisement

loading

This manual is also suitable for:

2500m