Changing The Battery - GE 27909 User Manual

CHANGING THE BATTERY

CAUTION: To reduce the risk of fire or personal injury, use
only the Thomson Inc. approved Nickel-metal Hydride (Ni-MH)
battery model 5-2734, which is compatible with this unit.
1. Make sure the telephone is OFF (not in TALK mode) before you
replace battery.
2. Remove the battery compartment door.
3. Disconnect the cord attached to the battery pack and remove the
battery pack from the handset.
4. Insert the new battery pack and connect the cord to the jack inside
the battery compartment.
5. Put the battery compartment door back on.
6. Place handset in the base or handset charge cradle to charge. Allow
the handset battery to properly charge (for
use or when you install a new battery pack. If you do not properly
charge the phone, battery performance will be compromised.
Battery Safety Precautions
‧ Do not burn, disassemble, mutilate, or puncture. Like other
batteries of this type, toxic materials could be released which can
cause injury.
‧ To reduce the risk of fire or personal injury, use only the Nickel-
metal Hydride battery listed in the User's Guide.
‧ Keep batteries out of the reach of children.
‧ Remove batteries if storing over 30 days.
Display Messages
The following messages show the status of the phone, provides Caller
ID information, or helps you set up and use your phone.
BLOCKED
DELETE ALL?
DELETE?
END OF LIST
ENTER NAME
ENTER NUMBER Prompt telling you to enter a telephone number.
NEW CALLS
HANDSET NAME Prompt telling you to enter a user name for the
14 hours) prior to first
UNAVAILABLE
No line
Line in use
Empty
Searching
Page from base
RPT
Unknown
Indicates the person is calling from a number
which is blocked from transmission.
Prompt asking if you want to erase all records.
Prompt asking if you want to erase the current
record.
Indicates that it is the end of the list.
Prompt telling you to enter a name.
Indicates call or calls which have not been
reviewed.
handset.
The handset is not yet registered or is out of
range.
Indicates that the telephone line is not connected.
Display on handset while the line is in use.
Indicates there are no CID records in memory.
Indicates handset is too far away from the base,
and the handset is searching for the base.
Someone pressed the PAGE button on the base.
Indicates a repeat call message. Indicates a new
call from the same number was received more
than once.
Indicates incoming call is from an area not
serviced by CID or the CID information was not
sent.
20