GD Midea Refrigeration Equipment Elite Series Technical & Service Manual page 27

8.8.1.3 During the start-up and operation, all of the following protecting functions work:
3minutes start-up delay protection, overload protection, outdoor protection, evaporator
Protection against low temperature. If any of the protection functions, the comparative protecting
action is executed.
The forced cooling mode is closed by one touch on the button, meanwhile the operation light is off,
the buzzer buzzes lasts for 1 seconds, then A/C turns to be closedown status.
8.8.2. Forced Auto
8.8.2.1 Remote control signal can be received in forced auto mode. When receiving the signals, the
forced auto mode will be canceled and the A/C changes to remote control status and performs
operation as the signals indicates.
8.8.2.2 The system performs control according to the remote control auto mode with a set temperature of
24°c.
8.9 Timer
24 hours timer on or off.
8.10 Protecting Function
8.10.1 Compress with a delay of 3 minutes.
8.10.2 Sensor open and break protection
8.10.3 EEPROM error protection.
8.10.4 Current protection function.
Current up
Current
down
8.11 Auto restart Function
In case of a sudden power failure, this function automatically sets the unit to previous
settings before the power failure when power returns.
Condition Indoor fan
I< I
RESTORE
I <I< I
RESTORE FAN
I <I<I
FAN 5MIN
I <I< I
5MIN 3SEC
I <I< I
5MIN 3SEC
I <I<I
FAN 5MIN
I <I< I
RESTORE FAN
I< I
RESTORE
Compressor
On On
On On
Low speed On
Off
Off
Off
Off
On On
Low speed On
On On
26
Outdoor fan Remark
On
Off Heating mode
On Cooling mode
Off After 5 Minutes
Off After 3 Seconds
Off After 3 Seconds
Off After 5 Minutes
Off Heating mode
On Cooling mode
On