Kenwood TK-7185 Service Manual Addendum page 14

TK-7185
9-2. Installing the GPS receiver together with the VGS-1
1. Remove the cabinet, top packing and shielding plate of
the transceiver.
2. Remove the front panel from the transceiver.
3. Attach a cushion to the bottom of the VGS-1 as shown in
Figure 9-5.
Note: Be sure not to cover the connector with the cush-
ion.
4. Insert the VGS-1 connector (CN1) into the TX-RX unit (B/3)
connector (CN403).
5. Perform step 3 to 6 of "9-1. Installing the GPS receiver"
described on page 13.
Note: You must setup using the KPG-92D.
GND (GND)
RXD2 (DATA OUT1)
5E (+5V)
14
INSTALLATION
TX-RX unit (B/3)
Solder land
RXD1
TXD1
TXD2
OPT1
OPT3
OPT4
OPT5
DTI
TCTL
TXO
AUDIH
OPT2
STON
RXEO
TXI
RXEI
OPT6
8C
Fig. 9-4
GPS receiver
VGS-1
CN1
CN403
Fig. 9-5