Advertisement
Glossary
Terminology
The terminology used in this manual is specific and individual interpretation
must not be introduced. The terms are defined as follows:
Adjust
To bring to a more satisfactory state; to manipulate controls,
levers, linkages, etc. to return equipment from an out-of-tolerance
condition to an in-tolerance condition.
Align
To bring into line; to line up; to bring into precise adjustment,
correct relative position or coincidence.
Calibrate:
To determine accuracy, deviation or variation by special
measurement or by comparison with a standard.
Check:
Make a comparison of a measure of time, pressure, temperature,
resistance, dimension or other quality with a known figure for that
measurement.
Disconnect: To detach the connection between; to separate keyed or matched
equipment parts.
Examine:
To perform a critical visual observation or check for specific
conditions; to test the condition of.
Inspect:
Review the work carried out by Specialists to ensure it has been
performed satisfactorily.
Maintain:
To hold or keep in any particular state or condition especially in a
state of efficiency or validity.
Operate:
Make sure that an item or system functions correctly as far as
possible without the use of test equipment or reference to
measurement.
Readjust:
To adjust again; to move back to a specified condition; to bring
back to an in-tolerance condition.
Reconnect: To rejoin or refasten that which has been separated.
Reset:
To put back into a desired position, adjustment or condition.
Druck DPI 142/150 Calibration Manual
iii
K382 Issue No. 1
Hide quick links:
Advertisement
