Advertisement
Analog Door Phone
Model LUADS
Installation and Use Manual
•
Telephone line powered
•
Two-way, hands-free communication
•
Vandal-resistant brushed stainless steel faceplate with
mounting gasket and heavy-duty call button
•
Adjustable microphone and speaker volume
•
Adjustable call timer duration
•
Defeatable call timer
•
Responds to forward disconnect
•
Selectable Auto Answer feature allows remote monitoring
© 2003 Bogen Communications, Inc.
All rights reserved. 54-2106-01A 0312
Printed in Taiwan.
Specifications subject to change without notice.
Issue 1, December 2003
Advertisement
Table of Contents
Related Manuals for Avaya LUADS
Summary of Contents for Avaya LUADS
- Page 1 Analog Door Phone Model LUADS Installation and Use Manual • Telephone line powered • Two-way, hands-free communication • Vandal-resistant brushed stainless steel faceplate with mounting gasket and heavy-duty call button • Adjustable microphone and speaker volume • Adjustable call timer duration •...
- Page 2 Notice Every effort was made to ensure that the information in this manual was complete and accurate at the time of printing. However, information is subject to change. Important Safety Information Always follow these basic safety precautions when installing and using the system: Read and understand all instructions.
- Page 3 When the call is initiated by another phone (Auto Answer), then the timer starts once the unit answers the call. With the timer disabled, the call time will be unlimited and the LUADS will not disconnect the call until a 300 ms or longer loss of loop current is detected. If your telephone line/phone system extension does not supply a loop current break when the calling party hangs up, then the call timer feature must be used (enabled).
- Page 4 Programming...
- Page 5 Wiring Phone Connection To connect the LUADS to a phone system, simply connect the analog station line to the RJ11, which is already wired to a pluggable terminal block that is preassembled to the cir- cuit board.The connections to the terminal block are not polarity sensitive.
- Page 6 Installation The LUADS comes with a standard dual gang electrical box. Make all electrical connections prior to installing the LUADS into the electrical box. Surface Mounting the LUADS (Indoor/Outdoor) 1. Mount electrical box. Make electrical connections (see Wiring) and attach the faceplate to the electrical box using the four hex drive screws (tool provided).
- Page 7 Specifications Power: Telephone line powered (18V DC / 20 mA minimum) Timer Duration: 15 seconds to 2 minutes Loop Current Loss Disconnect: 300 ms minimum Ring Voltage: 40V AC RMS minimum REN: 0.7A Connections: RJ11 pre-wired to a 2-position pluggable terminal block Earth Ground lug Dimensions:...
Need help?
Do you have a question about the LUADS and is the answer not in the manual?
Questions and answers