Napoleon AK8 Installation Instructions

Included in the AK8 kit:
ITEM # PART#
1 W263-0096
2 W263-0098
3 W263-0097
4 W385-0334
W570-0001
W570-0006
W570-0020
W735-0026
W450-0008
AK8 INSTALLATION
1. Secure the Right Flashing to the right side of the unit using two
of the #8 x 1/2" screws. NOTE: Feed the Air Control Rod into
the Air Control Slot on the Right Flashing before securing.
(FIGURE 1)
FIGURE 1
AIR
CONTROL
SLOT
2. Twist spring handle (supplied with the heater) onto the air
control rod until it hits the stop.
3. Remove the two control panel securing screws, discard the
screws and shipping bracket.
(FIGURE 2)
4. Secure the control panel to the Right Flashing using the two
#8 x 3/8" screws. (FIGURE 2) Secure the Left Flashing with the
remaining #8 x 1/2" screws.
AK8 AND GICSK
INSTALLATION INSTRUCTIONS
FOR MODEL NPI-40
DESCRIPTION
Top Flashing
Left Flashing
Right Flashing
Napoleon Logo
Screw, #8 x 3/8"
Screw, #8 x 1/2"
Screw, #8-32 x 3/8"
Lock Washer, #8
Nut, #8-32 Hex
AIR
CONTROL
ROD
RIGHT
FLASHING
BURN
RATE LABEL
1
1 / "
2
QTY
1
1
1
2
1
2
4
4
4
4
Shown with AK8 and GICSK installed
5. Align the holes in
4 the top of the Right
and Left Flashing
with those on the
bottom lip of the Top
Flashing and secure
from the rear using
the four #8-32 x 3/8"
screws, washers and
nuts. (FIGURE 3)
6. Affi x the burn rate
label under the slots
on the right fl ashing 1 1/2" in from the inside edge, with the word
"LOW" to the left. (FIGURE 1)
FIGURE 3
CONTROL
PANEL
GICSK INSTALLATION
Refer to steps #11 and #12, as well as all warnings, in the
instructions included with your GICSK kit for installation.
NOTE: Affi x the logo to the bottom left hand corner
of the left fl ashing after the GICSK has been installed.
W415-0656 / C / 10.19.11
1
3
SHIPPING CONTROL
BRACKET PANEL
FIGURE 2
SECURING SECURING
SCREWS SCREWS
TOP
FLASHING