Philips 32PF9968/10 Service Manual page 9

Figure 4-6 Speaker-2
4.3.5 Power Supply Board
1. Refer to next figure.
2. Unplug all the connectors [1].
3. Remove the fixation screws [2]
4. Remove the board.
Figure 4-7 Power supply board
4.3.6 Scaler Board (SB)
Caution: it is absolutely mandatory to remount all different
screws at their original position during re-assembly. Failure to
do so may result in damaging the SB.
Removing the SB Side Screws
1. See the figure"Scaler board".
2. Remove the parker screws [1]
3. Unplug five cables [2]
2
1
I_17940_008.eps
300508
1
2
I_17940_009.eps
300508
Mechanical Instructions
4.4 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
• While re-assembling, make sure that all cables are placed
and connected in their original position. See figure "Cable
dressing".
• Pay special attention not to damage the EMC foams at the
SSB shielding. Check that EMC foams are put correctly on
their places.
TPM1.2HU LA 4.
2
2
1
Figure 4-8 Scaler Board
EN 9
I_17940_010.eps
300508