GE Evolve EFM1 Installation Manual page 2

1
UNPACKING/HANDLING
• Inspect luminaire to confirm no damage has occurred
during transit.
• To avoid damage, do not impact or stack luminaire
after removal from packaging.
2
MOUNTING
2a. Pipe Mount:
Mount on vertical 1-7/8 to 2-3/8-inch
O.D. or 2-3/8 to 3-inch O.D. pipes.
• Pipe must point upward such that gravity acts to hold
luminaire on pipe end.
• Do not mount unit upside down.
• Tighten set screws to 25-30 ft-lbs (34-41 N-m) of torque.
• Tighten Knuckle Bolt to 15 to 20 ft-lbs torque after aiming.
Risk of injury or damage. Unit will fall if not installed
properly. Do NOT exceed 30 ft-lbs of torque on set screws
or 20 ft-lbs of torque on knuckle bolt.
2b. Wall Mount:
Mount to vertical surface using four
0.43-inch clearance holes spaced 4.37(H) x 2.87(V) inches
with customer supplied fasteners/anchors.
• Seal wall mount flange to the mounting surface
with silicone caulk or equivalent.
• Tighten Knuckle Bolt to 15 to 20 ft-lbs torque after aiming.
Risk of injury or damage. Unit will fall if not installed
properly. Do NOT exceed 20 ft-lbs of torque on knuckle bolt.
2c. Trunnion Mount:
customer supplied 3/4-inch bolt through the clearnace
hole provided in the trunion bottom.
• Tighten two (2) side Trunion Bolts to 15 to 20 ft-lbs
torque after aiming.
• If desired, trunion can be secured against rotation
by using customer supplied fastner(s) through
additional clearance holes in the trunion bottom.
Risk of injury or damage. Unit will fall if not installed
properly. Do NOT exceed 20 ft-lbs of torque on trunnion bolt.
WARNING
WARNING
Mount on a flat surface using a
WARNING
FIGURE 1. Pipe Mount
2.875 in.
4 Holes
.430 in.
FIGURE 2. Wall Mount
Clearance hole for Customer
Supplied 3/4" Bolt
FIGURE 3. Trunnion Mount
Knuckle Bolt
Wiring Cover
Set Screws
Top Closure Screw
Door Hinge
Wiring Cover
Knuckle Bolt
4.375 in.
Trunnion Bolt