Advertisement
T5HO Hybrid Fixtures (White with Decor Endcaps)
Models: 420558, 420559, 420560, 420561
Installation, Operation & Maintenance Guide
Step 6 – Install your LED fixture onto one or several of
the LED brackets. The rectangular bracket has multiple slots
where a screw can pass through to secure the LED fixture.
IMPORTANT: Before installing the Decor Endcap, thread each of the outer
Step 7
sheet metal screws into the holes in the new metal endplate. When the
screws are halfway into the hole, remove them for next step.
Step 8 – Place the fixture power cord in the lower channel
and the LED cords in the upper channel of the decor endcap.
The LED cords will route through the "U" cutouts on top of
the endplate.
3
IMPORTANT!
Pre-thread two screws on
each end of the fixture
A
Step 9 – Position the decor endcap over the four open holes
on the new endplate.
Step 10 – Using the metal (pointed) screws, attach the endcap
using the two outer holes. Place the non-pointed screws in the
two middle holes and secure with nuts.
Step 11 – Repeat steps for other end of fixture.
Step 12 – Create a loop at the top of the cables and secure
the cable by tightening the screws.
Suspend the fixture safely above the aquarium.
B
A
B
www.aquaticlife.com
Advertisement
