Table of Contents
Advertisement
Available languages
Available languages
Components
TY-WK103PV9 Wall-hanging bracket (Vertical mounting type)
Wall-hanging bracket
Base unit (L)
Points to note during installation
The wall-hanging bracket is for use in installing the Plasma Display to a vertical wall for viewing
purposes. Do not use it for any type of installation other than vertical wall installation.
In order to ensure correct, problem-free operation of the Plasma Display, do not install the Display in
any of the following places.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
When installing this wall-hanging bracket unit, use a fixing method appropriate to the type of wall.
Use commercially available bolts with a nominal diameter of 12 mm (0.5 inches) that are suited to
the wall material (steel frame, concrete, etc.) you are fitting the bracket to.
Fit so there is no contact between the attachment bolts or power cord and any metal inside the wall.
Insert the power cord plug for the Plasma Display into a wall outlet which is close and easily
accessible.
Provide adequate ventilation so that the temperature around the display does not rise above 40 °C
(104 °F). If there is insufficient movement of the air inside display, heat may build up inside the
display, and fire may result.
Spread a soft blanket or cloth over the floor so that the plasma display and floor will not be marked
or scratched during the assembly and installation work.
When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over
tightened.
Take sufficient care to ensure safety around you when performing the assembly and installation work
or while moving about during the course of the work.
(1)
L
Wall-hanging bracket
Base unit (R)
(1)
R
11
Advertisement
Table of Contents
