RCT Power 4.0 Setup & Installation

SETUP
Installation
Power Inverter
This setup manual contains a short instruction required
for installing, wiring, commissioning and operating the
inverters. For further instructions on installing or
operating, please refer to the detailed user manual which
you can access via www.rct-power.com.
RCT Power GmbH reserves the right to make changes
to specifications or documents without prior notice.
RCT Power GmbH shall not be responsible for any
damages resulting from use of this document.
This document does not replace any applicable laws,
regulations, standards or codes.
Warranty conditions come enclosed with the device.
No warranties can be derived from this document.

Intended Product Usage

To prevent personal injury or property
damage, the inverter must only be installed,
wired, connected, commissioned, maintained
and serviced by qualified personnel:
•
Trained in installing electrical devices.
•
Familiar with all applicable laws, regulations,
standards and codes for electrical devices.
•
Familiar with safety requirements and safety-related
guidelines for electrical devices.
•
Familiar with work protection laws and regulations.
•
Using the appropriate personal protective equipment.
4.0 / 5.0 / 6.0
Symbols
Explanation
Immediate
danger of death
or serious injury
Immediate
danger of minor
or moderate
injury
Danger of
equipment or
property damage
Power Inverter 4.0, 5.0 and 6.0 are stationary 3-phase
string inverters. They convert direct current (DC) supplied
by the PV array into alternating current (AC), which can be
fed into the electricity grid.
They are not designed for any other application or
connection to other devices.
Any use that differs from or goes beyond the intended
usage is considered misuse. RCT Power GmbH shall not
be liable for any damage resulting from misuse.
Any misuse will terminate warranty, guarantee and general
liability of the manufacturer.
1
Level of risk
high medium low
EN