Table of Contents
Advertisement
PROBLEM
Too much ice forming on back wall of
refrigerator section (layer of frost
more than 1 cm thick):
Too much ice forming in freezer
Front of cabinet hot to the touch
Doors
misaligned
FAB28)
18
Instructions for the user
-
Cooling
device set too high (meaning
lower
appliance);
-
door opened often or for long
periods;
-
inside
thermostat set on too low a
temperature;
-
(except
mod.
-
POSSIBLE CAUSE
temperature
regulator
temperature
inside
temperature
setting
PROBABLE SOLUTION
-
Turn the regulator to a lower
setting (1-2) to increase the
the
temperature inside the appliance
slightly;
-
check
that
the
providing an airtight seal;
-
open the door less often and for
shorter times;
-
rise in atmospheric temperature
and humidity;
-
do not place hot food or drinks
inside the refrigerator;
-
Turn the regulator to a lower
setting (1-2) to increase the
temperature inside the appliance
slightly;
-
check
that
the
providing an airtight seal: If they
are cracked, try to soften the
gasket by pulling it with one hand
and sliding your closed fingers
along the inside;
-
open the door less often and for
shorter times;
-
rise in atmospheric temperature
and humidity;
-
do not place hot food or drinks
inside the freezer;
-
the
refrigerator
normally. Inside the cabinet there
is
a
surface
designed to restrict the formation
of condensation in the area where
the door gasket closes.
-
check that the refrigerator is
levelled properly, also adjusting
the two rear feet if necessary.
Check
whether
settings of the two feet improves
the alignment.
gaskets
are
gaskets
are
is
operating
cooling
system
changing
the
Hide quick links:
Advertisement
Table of Contents
