Care And Safety; Installing The Battery - Intelbras twin User Manual

CARE AND SAFETY

Never open your radio.
Never change or substitute any part in your radio except the batter-
ies.
Your radio can cause interference in TV or radios even when ap-
propriately operated. Switch it off to determine if your radio is the
cause of interference. If interference stops, your radio is the cause.
Only use a dry and clean cloth to clean the radio. If the radio is
exposed to moist, immediately switch it off and remove the batter-
ies. Clean the battery compartment with a dry cloth to avoid dam-
age by water. Next, immediately take the device to an authorized
technical assistance.
If the radio is to be kept for long periods of time, remove the batter-
ies because they corrode with time and can damage your radio.
The people who use pacing device should:
Always keep the radio at a distance of over 15 cm from the pac-
ing device when the radio is switched on.
Do not carry the radio in the shirt pocket.
Use the ear opposite the pacing device to reduce interference
potential.
Immediately switch off the radio when there is suspicion of in-
terference.
The batteries should be handed to Intelbras authorized technical
assistance or another point of collection at the end of its life cycle
for appropriate disposal.
For being a Radiocommunication Equipment of general use, the
equipment user, at any time or in any channel, should give priority
to the emergency communication messages related to life safety.
INTELBRAS TWIN

INSTALLING THE BATTERY

1 Ensure that the radio is switched off.
2 Remove the battery compartment door by pressing the tab at the
bottom of the compartment door, and remove the cover.
3 Install the battery kit in the compartment. The battery should stay
with the contacts out and downwards.
4 Replace the battery compartment door.
Note
Always ensure that the battery is totally uncharged before recharging
it to prolong its life.
BATTERY CHARGE LEVEL AND LOW
BATTERY ALARM
This radio has a battery level meter on the display to indicate its sta-
tus. When the battery is low, the
Recharge the battery immediately or, if you are using alkaline batter-
ies, substitute to continue using the radio.
USING THE TABLE CHARGER
Ensure that the radios are switched off before charging so that the
battery meter indicates correctly.
1 Connect the AC/DC converter in the DC IN 9~11 V jack and in a 110/
220 V AC plug.
2 Place the chargers on the flat surface and insert the radios with the
keypad facing forward.
3 Ensure that the charge indicator comes on. Charge the batteries for
16 hours and remove the radios from the chargers after charging.
15
icon will blink.
ENGLISH