Silencer Security Systems SLRF8 Owner's Manual

Vehicle immobilizer

Table of Contents

Download this manual

4900UM

3/2/04

12:59 PM

Page 1

O W N E R ' S

M A N U A L

Model: SLRF8

Vehicle Immobilizer

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference; and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to

this equipment. Such modifications could void the user's authority to operate the equipment.

Table of Contents

Need help?

Do you have a question about the SLRF8 and is the answer not in the manual?

Page 1 Page 1 O W N E R ’ S M A N U A L Model: SLRF8 Vehicle Immobilizer This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation.
Page 2 4900UM 3/2/04 12:59 PM Page 2 Welcome to the world of Silencer ® automotive security. Silencer automotive security products have been designed to provide the consumer with a product that is technologically superior, providing years of trouble free operation. This manual will provide reference for the operation and maintenance of your new Silencer vehicle immobilizer system.
Page 3 4900UM 3/2/04 12:59 PM Page 3 RF Protection Mode Each time the system is disarmed using the transmitter, the device will begin a protection mode countdown. This is a timed secondary protection mode to insure the RF signal that disarmed the system came from your transmitter.
Page 4 4900UM 3/2/04 12:59 PM Page 4 Battery Replacement To replace (or remove for storage) the batteries in your transmitter, follow this procedure: 1. Turn the transmitter over and locate the slot at the edge of the transmitter case. 2. Use a small flathead screwdriver to pry apart the top and bottom case of the transmitter while keeping the button side facing downward.