Preservation Instructions - iceqube EX series Operation And Installation Manual

Unpacking Inspection
Caution: It is recommended using gloves and protective eyewear when unpacking
Verify product is as identified on the packing list. Air conditioner should arrive banded to pallet and
wrapped with an outer protective clear plastic membrane material in the proper upright position. See arrows
on packaging for verification. Any evidence of damage should be noted on the freight bill. The freight
carriers claim procedure should be followed. Ice Qube cannot accept responsibility for damages that
occur during shipping. If the shipping container was damaged or marred in any way, check for scratches,
dents, loose hardware, presence of oil or any other irregularities with the Ice Qube TMS.
Package Contents
Included in the shipment with the air conditioner will be:
1. Operation manual
2. Mounting hardware
3. (2) Bolts w/ washer for replacing lifting lugs after final installation
Handling
Ice Qube recommends that the unit remains in the proper upright position, as indicated on the shipping
container. The unit must remain upright for a minimum of 24 hours before initial operation to ensure oil
has returned to the compressor. Operation before the 24-hour time may cause compressor damage and
shorten the life of the system. Operation before this 24-hour period will void all warranties.
Storage
It is recommended the air conditioner be stored in the original packaging in a secure area where it will not
be damaged. If the packaging is to be removed, use lifting lugs to move the air conditioner. Before use,
check that the lifting lugs on top of the air conditioner are secure and have not loosened during shipment.
The storage space temperature should be in the range of -40 to 60°C (-40 to 140°F) in a non-condensing
environment with a relative humidity of 0 to 95%.
CONDITIONS OF ACCEPTABILITY:
1. Please contact Ice Qube with any questions regarding services before opening or altering the
system from its original factory configuration.
2. Surfaces are to be cleaned only with a damp cloth to avoid build-up of electrostatic charge.
3. Cable type should be a flexible conduit that is effectively clamped to prevent twisting and pulling.

Preservation Instructions

When installed in the end use equipment, the following
considerations are to be examined:
4
Rev. 1