Page 2
Introduction: The Minimote is a fully functional Z-Wave remote control capable of adding, removing and controlling other Z-Wave devices. Advanced functions include automatic rediscovery of the Z- Wave network and becoming a secondary or inclusion controller to a SIS gateway in the Z- Wave network.
Page 3
2 seconds to indicate failure. 4. Repeat step #2 for all products you wish to add into the Z-Wave network or press any button on the Minimote to exit Inclusion-Mode. (The blue LED will be blinking slowly as in step #1 while in Inclusion-Mode.) Note: Secondary Controllers are not able to include Z-Wave products;...
Page 4
2. Press the Z-Wave button on the product you wish add/remove (while still holding the scene button from the previous step) - The blue LED on the Minimote will stay solid to indicate the device has entered the scene.* 3.
Page 5
LED will stay solid for 2 seconds to indicate failure. 4. Repeat step #3 for all sensors you wish to be controlling the device in step #2 or press any button on the Minimote to exit Association-Mode. (The blue LED should be blinking quickly again as in step #3.) •...
Page 6
Z-Wave network to become the new primary/master controller of the network. 2. Press and hold both the buttons labeled “Include” and “Remove” on the Minimote for 10 seconds – The blue and red LEDs will blink from slow to fast.
Page 7
FCC NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.
Need help?
Do you have a question about the Minimote and is the answer not in the manual?
Questions and answers