Drummond Hood Mate Pipet-Aid 300 Installation & Operation Manual

Advertisement

Drummond Scientific
Installation & Operation
Catalog Number 4-000-300
Hood Mate
This equipment is for indoor use only.
(Maximum temperature 35°C, Maximum Humidity 60%)
Rating
Input
Pipet Capacity
Maximum Fill Rate
CAUTION:
Company
Manual for Model 300
Specifications
CAREFULLY READ THROUGH THIS ENTIRE
MANUAL BEFORE USING YOUR NEW
PIPET-AID. PAY CLOSE ATTENTION TO
THE RULES FOR SAFE OPERATION
WARNINGS AND CAUTIONS.
Made in USA
500 Parkway, Broomall, PA 19008
800/523-7480 • 610/353-0200 • FAX: 610/353-6204
www.drummondsci.com • www.pipet-aid.com
Pipet-Aid
®
120 Volts, 60 Hz AC
Installation Category II
Pollution Degree One
6.3 VA
Any pipet with a mouth
piece diameter 3 mm to
10 mm
10 mL/sec
By
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hood Mate Pipet-Aid 300 and is the answer not in the manual?

Questions and answers

Summary of Contents for Drummond Hood Mate Pipet-Aid 300

  • Page 1 Drummond Scientific Company Installation & Operation Manual for Model 300 Catalog Number 4-000-300 Hood Mate Pipet-Aid ® ® This equipment is for indoor use only. (Maximum temperature 35°C, Maximum Humidity 60%) Specifications Rating 120 Volts, 60 Hz AC Installation Category II...
  • Page 2 Do not operate unit with a damaged cord. • Do not handle power supply with wet hands. • PIPETTING ACIDS OR STRONG ALKALIS WILL DAMAGE UNIT. • When servicing, use only identical Drummond • replacement parts. Save these instructions. •...
  • Page 3 INSTALLATION F F i i g g u u r r e e 1 1 Coiled Hose Hook Mounting Bracket Holster Adhesive Hood Mate ® Tape Body Pipet-Aid ® Handle Power Supply A A p p p p l l y y i i n n g g t t h h e e M M o o u u n n t t i i n n g g B B r r a a c c k k e e t t Determine a suitable area to place the mounting bracket and clean the surface with isopropyl alcohol.
  • Page 4 C C o o n n n n e e c c t t i i n n g g t t h h e e P P o o w w e e r r S S u u p p p p l l y y Use only the power supply that is supplied with the unit.
  • Page 5 Operation P P a a r r k k i i n n g g t t h h e e H H a a n n d d l l e e The Handle can be “parked” on the Hood Mate body two ways as shown in Figure 4 and Figure 5.
  • Page 6 Check the rubber insert for blockage. Drummond d d o o e e s s n n o o t t u u s s e e c c o o t t t t o o n n .
  • Page 7 The specifications for the Drummond filter are .45 µm for the hydrophilic layer and .8 µm for the hydrophobic layer. Most competitive pipetting units use a single layer hydrophobic membrane with ratings of either .22 µm or .45 µm. These filters protect the handle only. If challenged with an aqueous solution, the filter will prevent the liquid from entering the handle;...
  • Page 8 ©Copyright Drummond Scientific Company, 2002, Rev. 5/04, Printed in USA Hood Mate® is a registered trademark of Drummond Scientific Company...

Table of Contents