Subscribe to Our Youtube Channel
Related Manuals for Drummond Nanoject III
Summary of Contents for Drummond Nanoject III
- Page 1 Nanoject Programmable Nanoliter njector INSTRUCTION MANUAL • 3-000-207 MADE IN USA LABORATORY EQUIPMENT E21997...
- Page 2 If any damage is noted, do not use the Nanoject III until the damaged mains is replaced. Connecting to power outlet: The control box has a power source transformer attached to the box.
- Page 3 4) Turn on unit with the on/off switch located on the left hand side of the control box. 5) Initially the Drummond logo will be displayed on the screen and then the operational mode screen will appear with the following icons: Select the manual mode by pressing the [MANUAL] icon.
- Page 4 Operational Modes [MANUAL] Mode This mode will enable the user to manually fill and empty the micropipet. Pressing the [FILL] icon will retract the wire plunger, while pressing the [EMPTY] icon will cause the wire plunger to extend. When the [HOME] icon is pressed, the wire plunger will fully retract to the “home”...
- Page 5 [PROGRAM] Mode This mode enables the user to program multiple injection cycle recipes. To program a new recipe, press the [NEW] icon. A screen displaying the sample injection volume (nL) and an injection rate (nL/sec) will appear. As before, adjust these individual values by using the respective [+] and [-] icons.
- Page 6 Press the [EXIT] icon to exit back to the operational mode screen. Notes The Nanoject III does not use any O-rings to secure the micropipet. We have incorporated a small chuck and a silicon receiver for the glass micropipet. The micropipet should slide easily onto the wire, provided the collet has been loosened enough.
- Page 7 Questions, Comments, Suggestions or Service: CALL OUR HOTLINE AT 1-800-523-7480 Power Source supplied with four inter- changeable adapter plugs for use in the U.S., UK, Europe, and Australia Specifications Part Number ........3-000-207 Power Source .
- Page 8 Questions: Please contact Chuck Locke at 800-523-7480 or clocke@drummondsci.com if you need any assistance. For Technical Assistance, call 500 Parkway, Box 700 1-800-523-7480 or e-mail Broomall, PA 19008 info@drummondsci.com 800/523-7480 • FAX: 610/353-6204 Website: www.drummondsci.com ©Copyright, Drummond Scientific Company, 2016, Rev. 0416 Printed in USA...
Need help?
Do you have a question about the Nanoject III and is the answer not in the manual?
Questions and answers