Table of Contents
Advertisement
Quick Links
Sensative
STRIPS Door and Window Sensor
SKU: SENE1110
Quickstart
This is a Alarm Sensor for Europe. To run this device please insert fresh 1 * built in LiMnO2 batteries. Please make sure the internal battery is
fully charged. Strips is delivered in "auto-add" mode. Follow the process below to add Strips in a Z-Wave network.
1. Start the add mode on the Z-Wave controller. See the controller's manual.
2. Remove both magnets from Strips. Strips blinks twice to confirm the command and successful addition.
3. A long LED blink indicates that the add process was successful
4. The Z-Wave controller application should now allow you to monitor your Strips sensor status.
5. Move the squared magnet as shown in the picture . Check that the Z-Wave system indicates the status correctly
What is Z-Wave?
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart
section.
Z-Wave ensures a reliable communication by reconfirming every message ( two-way communication)
and every mains powered node can act as a repeater for other nodes (meshed network) in case the
receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used together with any other certified Z-
Wave device regardless of brand and origin as long as both are suited for the same frequency
range.
If a device supports secure communication it will communicate with other devices secure as long as
this device provides the same or a higher level of security. Otherwise it will automatically turn into a
lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Product Description
Strips by Sensative is an ultra-thin magnetic sensor designed to monitor windows and doors for your safety. It´s so thin that it can be mounted invisibly in
the tiny gap between the frame and the door or window.
It is as easy to mount as a sticker using Strips"s adhesive tape.
Strips is Z-Wave plus compliant and can be used with any existing Z-Wave smarthome systems.
Prepare for Installation / Reset
Please read the user manual before installing the product.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Sensative SENE1110
Summary of Contents for Sensative SENE1110
-
Page 1: Product Description
Product Description Strips by Sensative is an ultra-thin magnetic sensor designed to monitor windows and doors for your safety. It´s so thin that it can be mounted invisibly in the tiny gap between the frame and the door or window. - Page 2 In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
-
Page 3: Technical Data
time is significantly decreased. This device will wakeup regularly and announce the wakeup state by sending out a so called Wakeup Notification. The controller can then empty the mailbox. Therefore, the device needs to be configured with the desired wakeup interval and the node ID of the controller. If the device was included by a static controller this controller will usually perform all necessary configurations. - Page 4 Certification ID ZC10-16045049 Z-Wave Product Id 0x019A.0x0003.0x0003 Supported Command Classes Association Group Information Association V2 Battery Sensor Binary Configuration Device Reset Locally Manufacturer Specific Notification V4 Powerlevel Version V2 Wake Up V2 Zwaveplus Info V2 Explanation of Z-Wave specific terms Controller —...
Need help?
Do you have a question about the SENE1110 and is the answer not in the manual?
Questions and answers