1. Manuals
  2. Brands
  3. Fuji Clean Manuals
  4. Water Filtration Systems
  5. Residential CE Series
  6. Installation manual

Fuji Clean Residential CE Series Installation Manual

Residential systems ce and cen models
Hide thumbs
Table of Contents

Advertisement

Quick Links

Warranty Activation
To activate system warranty, Fuji
Clean USA must receive Warranty
Activation Card! Please see page 13.
Contractor Installation Manual
Residential Systems
CE and CEN Models
Rev. 2-25-18
Please Note:
Product warranty requires proper system
installation as described in this Manual.
Fuji Clean USA ● 41-2 Greenwood Road ● Brunswick Maine 04011 ● Tel: 207-406-2927 ● Fax: 207-406-2929 ●
www.fujicleanusa.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Residential CE Series and is the answer not in the manual?

Questions and answers

Related Manuals for Fuji Clean Residential CE Series

Summary of Contents for Fuji Clean Residential CE Series

  • Page 1 Residential Systems CE and CEN Models Rev. 2-25-18 Please Note: Product warranty requires proper system installation as described in this Manual. Fuji Clean USA ● 41-2 Greenwood Road ● Brunswick Maine 04011 ● Tel: 207-406-2927 ● Fax: 207-406-2929 ● www.fujicleanusa.com...

  • Page 2: Installation Manual

    Thank you for choosing to install a Fuji Clean USA treatment system. We care that the system is installed properly and thoughtfully. Fuji Clean USA or your qualified distributor will train and certify you for proper installation. PLEASE contact your distributor or Fuji Clean USA for assistance or with ANY questions.
  • Page 3 (min. R-Value 8) over the upper half of the treatment tank. Septic Tank and/or Pump Station. If local code or site conditions mandate. Fuji Clean system are designed to accept straight wastewater. Fresh Water Systems must be filled with fresh water to Low Water Mark (LWM) before start-up. Approx. gallons required per model: (CE5: 435;...

  • Page 4: Installation Overview

    Using grommets or a waterproof adhesive, labels meeting NSF standards (supplied by Fuji Clean USA) shall be affixed in two locations, inside the inlet riser and on the inside of the controller.
  • Page 5 Section 2. Treatment Process Overview Fuji Clean’s “contact filtration” treatment is a simple, well engineered process that consists of a controlled, circuitous flow train through anaerobic and aerobic chambers and in direct contact with assorted proprietary fixed film medias on which biological digestion of organic matter occurs. Media is also designed and positioned to provide mechanical filtration of process wastewater.

  • Page 6: Installation Procedure

    Installation Procedure Unloading Instructions:  Upon delivery, inspect Fuji Clean tank, both outside and inside for possible damage incurred during transport. If you find damage, or have a question, please contact your distributor immediately.  Step 1: Prepare excavation to be at least 1 to 2 feet ...
  • Page 7 Recommended uplift restraint options include: Uplift Restraint with Tie-Down Straps Do NOT use Lifting Lugs for uplift restraint. Tie down straps Cable tie-down detail. Uplift Restraint with Concrete Collar Fuji Clean USA * 207-406-2927 * www.fujicleanusa.com...
  • Page 8 Please note: To assure tank water tightness, please check in 24 hours to be sure that the water level has not dropped. Please contact your distributor or Fuji Clean USA if water level has dropped.  Step 6: Backfill about ¾ way up tank in layered, compacted 6”...
  • Page 9 OF TREATMENT TANK AND WITH NO MORE THAN FIVE (5) ELBOWS. If site conditions prevent this, please contact your distributor or Fuji Clean USA for technical assistance. Air Blower shall be:  in as close proximity to control panel as possible ...
  • Page 10 Air Pressure Sensing Alarm activity  For additional important detail about installing and maintaining blower, please review and refer to provided FujiMAC Blower Installation-Maintenance Manual, which is provided inside the blower box. Fuji Clean USA * 207-406-2927 * www.fujicleanusa.com...
  • Page 11 4” Sched. 40 pipe Seal around inlet and outlet 1-inch must be cut as shown to fit tank fittings using a sealant deep cuts completely into fitting. that meets ASTM C990-96 standards Fuji Clean USA * 207-406-2927 * www.fujicleanusa.com...
  • Page 12  Step 12: In nearly all cases, the Fuji Clean system will vent properly through the house septic influent line. In cases where there is a influent pump, or in severe downdraft locations, a separate vent should be considered. If you do choose to install a vent, be sure that the vent slopes toward the tank so that any moisture accumulation drips back down toward the tank.
  • Page 13 All conduits between panel and treatment tank must be sealed to prevent gas leakage into panel. Fuji Clean USA offers a choice of customized alarm/control panels, each with different features. Control panel customization is also available to match unique site or job requirements. Please consult Fuji Clean USA for details.
  • Page 14 Fuji Clean USA Controller “A” Circuit Alarm Circuit Breaker Breaker Float Switch, Pressure Switch, Test/Normal/ Air Blower Test/Normal/Silence Switch Silence Switch Circuit Breaker (Extra component if Alarm Beacon necessary, such as discharge pump) Pressure Switch Terminal Blocks Blower Hardwire Line...
  • Page 15 Controller “A” Wiring Diagram...
  • Page 16 Controller “C” Wiring Diagram...
  • Page 17 Float Switch Information The SJE Rhombus Signalmaster float switch is pre-mounted in Fuji Clean USA treatment systems. This information from SJE Rhombus is supplied for informed, proper handling during the installation process. ELECTRICAL SHOCK HAZARD EXPLOSION OR FIRE HAZARD Disconnect power before installing or servicing this Do not use this product with flammable liquids.

  • Page 18: Start-Up Procedures

    Fuji Clean USA * 41-2 Greenwood Road, Brunswick, ME 04011 207-406-2927 * www.fujicleanusa.com...
  • Page 19 If not, then check to be sure that there isn’t a clog in the airlift pipe with a cleaning brush. Fuji Clean USA * 41-2 Greenwood Road, Brunswick, ME 04011 207-406-2927 * www.fujicleanusa.com...
  • Page 20 Fuji Clean USA Owner’s Manual (with Warranty information included). • Be sure that service provider contact information is affixed to Alarm/Control Panel as well as on Homeowner’s Manual. Fuji Clean USA * 41-2 Greenwood Road, Brunswick, ME 04011 207-406-2927 * www.fujicleanusa.com...

  • Page 21: Troubleshooting

    TROUBLESHOOTING Air Blower What to observe How to solve the problem Status Blower is not working Power plug is Power plug Connect the power plug to the outlet. disconnected. Diaphragm is Replace the diaphragm kit. Alarm triggered damaged. Auto-stop Re-insert the auto-stop piece. (if alarm exists) function is activated.
  • Page 22 If you find damage, or have a question, please contact your distributor immediately.  Step 1: Prepare excavation to be at least 1 to 2 feet larger than the Fuji Clean tank dimensions. Note: Riser height should not exceed 24”.
  • Page 23  Step 11: Prepare Tank Inlet and Outlet for 4” Sched. 40 Inlet and Outlet Lines (secure with PVC cement).  Step 12: In nearly all cases, the Fuji Clean system will vent properly through the house septic influent line. In cases where there is an influent pump, or in severe downdraft locations, a separate vent should be considered.

This manual is also suitable for:

Residential cen seriesCe5Ce7Ce10Cen7Cen5 ... Show all

Table of Contents