Advertisement
This device is not intended for use by young persons(incliding children) with physical
sensory or mental
ledge, unless they have received from a person in charge of their safety adequate
supervision or preliminary instructions on how to use the device. Care must be taken
at all times to keep children from paying with the device.
Do not play with the appliance, jean against the front or insert objects or paper in it.
Do not totally or partially block the grilles on the front or inside of the appliance, as
this may cause overheating. If the supply cord is damaged, it must be replaced by a
service agent or similarly qualifi ed person in order to avoid a hazard (applies to units
fi tted with a supply cord and plug). Units fi tted with a three core supply cord (brown,
blue & black), must be directly connected to fi xed wiring by a licensed electrician. All
work on the interior of the appliance must be carried out by a licensed electrician.
To maintain performances of your unit, you should clean the upper and lower grilles of the unit about twice a year using
a vacuum cleaner or a brush.
Have a professional check the inside of the unit every fi ve years.
Dirt may collect on the grille of the unit if the atmosphere is polluted. This phenomenon is due to the poor quality of the
ambient air. In this case, it is recommended to check that the room is well ventilated (ventilation, air inlet, etc;..) and that
the air is clean. The until will not be replaced under the guarantee because of this type of dirt.
The unit casing should be cleaned with a damp cloth, never use abrasive products.
If the unit does not heat:
Check that the programmer is in COMFORT mode (electronical).
Make sure that the installation circuit breakers are switched on, or that the load shedder (if you have one) has not
switched off the unit power supply. Check the air temperature in the room.
The unit does not carry out programming orders: (version with pilot wire)
Make sure that the programming unit is being correctly used (refer to its user's manual) or that the Chronocarte is
properly inserted in its housing and that it is operating normally (batteries?).
The unit is permanently heating:
Make sure that it is not in a draft and that the temperature setting has not been changed.
This unit with electronic control is equipped with a microprocessor that can be disturbed by some severe mains
voltage disturbances (outside EC standards defi ning the disturbance protection level).
If there are any problems (thermostat blocked, etc.) switch off the unit power supply (fuse, circuit breaker, etc.) for
about 5 minutes to allow the unit to start again.
Have your energy distributor check your power supply if the phenomenon occurs frequently.
WARNINGS
disability, or by persons locking experience or know-
MAINTENANCE
TROUBLE-SHOOTING
Advertisement
