Advertisement
Quick Links
AlphaGateway SMG-00LI-01 Quick Start Guide
The SMG-00LI-01 is a strand-mounted HFC-powered, DOCSIS 3.0 LoRaWAN Gateway that utilizes the power, backhaul
and real-estate of the Broadband Access Network's aerial coax network to enable LoRaWAN communications.
Contains FCC ID: 2ALEPT0004564
ATTENTION:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
This product has been inspected by regulatory for use as described in the manual. If your intended use is different, it
is your responsibility to ensure your combination conforms to your local regulatory requirements and the Power Supply
remains within its environmental specifications.
6
2
6
7
1
5
1
1. AlphaGateway SMG-00LI-01, Vertical Orientation (PN: 018-354-20-001)
2. Active GPS Antenna (PN: 670-025-19)
2
3
3. LoRaWAN Antenna Ports
4. Coaxial F Connector Port (provides power to the SMG via power passing tap)
4
5. Status LEDs (located on bottom of unit)
5
6. Strand Mount Brackets (PN: 746-627-23-001)
6
7. Ground Lug Connection
7
8. 2-in-1 Combo Antenna, CH2P900 (PN: 670-024-19)
8
9. LoRa Antenna Cables, 50" (PN: 876-275-19), 75" (PN: 876-274-19)
9
018-354-B1-001, Rev. A (05/2018)
9
3
4
6
6
8
1
Advertisement
Related Manuals for Alpha SMG-00LI-01
Summary of Contents for Alpha SMG-00LI-01
- Page 1 AlphaGateway SMG-00LI-01 Quick Start Guide The SMG-00LI-01 is a strand-mounted HFC-powered, DOCSIS 3.0 LoRaWAN Gateway that utilizes the power, backhaul and real-estate of the Broadband Access Network’s aerial coax network to enable LoRaWAN communications. Contains FCC ID: 2ALEPT0004564 ATTENTION: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 2 SMG-00LI configurations: • SMG-00LI-01-00SL with 3” Strand Brackets, Vertical Orientation (PN: 018-354-20-001) • SMG-00LI-01-00S2 with 2” Strand Brackets, Horizontal Orientation (PN: 018-354-22-001) Bracket Kits: • 3” Strand Mount Bracket Kit for Vertical Orientation (PN: 746-627-23-001) NOTICE: A vertical SMG-00LI installation configured with the 2-in-1 Combo Antenna requires two sets of the 3” Strand Mount Bracket Kits (PN: 746-627-23-001).
-
Page 3: Pre-Installation
Pre-Installation Prior to Installation: • Provision the SMG’s DOCSIS Modem and RF MAC Address. This can include, but is not limited to: • Assign a cable modem configuration file with the CPE enabled, and the bandwidth set properly. • Set up a billing account (if applicable) •... - Page 4 2. Hang both brackets on the strand through the clamps on the bracket as shown. For thicker 3/8” strands, reverse the orientation of the clamp so that the larger concave side faces the strand. Insert the carriage bolt through the back of the bracket and tighten the hex head nut, lock washer, and flat washer against the clamp on the front of the bracket, torquing to 79.7 –...
- Page 5 4. Hang the antenna on the strand about 36” from the ports on the side of the SMG. For thicker 3/8” strands, reverse the orientation of the clamp so that the larger concave side faces the strand. Insert the carriage bolt through the back of the bracket and tighten the hex head nut, lock washer, and flat washer against the clamp on the front of the bracket, torquing to 79.7 –...
-
Page 6: Horizontal Installation
Horizontal Installation 1. Attach the GPS Antenna (PN: 670-025-19) to the SMG (PN: 018-354-22-001) using a 13/16” wrench and the included right angle adapter (PN: 659-014-10) as shown in the image below. Torque to 15 in-lbs (1.7 N-m). 2. Using the hex head bolts, lock washers, and flat washers, secure the strand brackets (PN: 746-627-22-001) to the SMG, torquing to 44.3 –... - Page 7 4. Using the hex head bolts, lock washers, and flat washers, secure the strand brackets (PN: 746-627-24-001) to the dual antenna module, torquing to 44.3 – 53.1 in-lbs (5 – 6 N-m). 5. Hang the antenna on the strand about 36” from the ports on the side of the SMG. For thicker 3/8” strands, reverse the orientation of the clamp so that the larger concave side faces the strand.
- Page 8 External Dipole Antenna Installation 1. Follow the standard installation steps 1 and 2 for hanging the SMG on the strand. 2. Attach each external dipole antenna to a strand mount bracket (PN: 746-627-31-001) using the included hardware, as shown below. Torque to 79.7 – 88.5 in-lbs (9 – 10 N-m). Hex head bolt Flat washer Lock washer...
-
Page 9: Start-Up And Verification
No Power / Downstream Carrier RF Carrier GREEN OFF / ON Power on, downstream carrier frequency searching detection and lock Downstream carrier lock NOTICE: For LoRaWAN operational details refer to the SMG-00LI-01 Technical Manual (PN: 018-354-B0-001). 018-354-B1-001, Rev. A (05/2018) - Page 10 Fax: +1 360 671 4936 Fax: +49 9122 79889 21 Fax: +561 792.7157 Fax: +852 2199.7988 Alpha reserves the right to change specifications without notice. Alpha Technologies © 2018 Alpha Technologies Inc. All Rights Reserved. Alpha is a registered trademark of Alpha Technologies.