Table of Contents
Advertisement
Charging Battery
Warning: Never charge more than 2 hours continuously.
Chargers should not be left plugged in or charging for more than 2 hours.
1.
Insert battery into the receptacle at the handle-bottom of the drill, sander, or flashlight.
2.
Secure the lock-spring clasps to each side of the handle.
Variable Speed Switch (11)
Chuck Sleeve
Variable Speed Trigger (5)
Inserting and Removing Drill and Screw Bits
The cordless drill is equipped with a keyless chuck. Follow these steps to insert bit.
1.
Set the rotation switch to the center (locked) position. See illustation that follows.
2.
Hold the chuck sleeve firmly while turning the chuck (15) counter-clockwise until the
opening is large enough to accept the drill bit or screw driver bit.
3.
Insert bit and turn chuck (15) clockwise until it is locked on the bit.
4.
Reverse procedures to remove a bit.
SKU 38358
(continued)
Inserting Battery into Unit
Chuck (15)
Torque Selector
Slotted Screw Bits (18)
Forward/Reverse Switch (13)
Lock Spring Release
Battery (20)
Page 5
Rev 09/98
Rev 04/02
REV 10/04
Rev 05/02,
Advertisement
Table of Contents
