Land Pride RCR1548 Operator's Manual page 27

Section 5: Maintenance & Lubrication
Clutch Assembly
Refer to Figure 4-4:
Reassemble each friction disc (#4) next to the metal plate
it was separated from. Make certain the bushing is
positioned as shown. Install bolts (#3) through the end
plates and intermediate plates as shown. Place
springs (#2) over the bolts and secure with nuts (#1).
Refer to Figure 4-5:
Progressively tighten each spring retainer nut until
correct spring length "A" is reached.
•
A = 1.26"
Clutch Adjustment
Figure 4-5
Long-Term Storage
Clean, inspect, service, and make necessary repairs to
the implement when storing it for long periods and at the
end of the season. This will help to ensure the unit is
ready for field use the next time you hook-up to it.
!
WARNING
To prevent serious injury or death:
•
Always disconnect driveline from power take-off shaft
before servicing drivetrain and cutter blades. The power
take-off can be engaged if tractor is started.
•
Always secure equipment with solid supports before
working under it. Never work under equipment supported
by concrete blocks or hydraulics. Concrete blocks can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
1. Clean off any dirt and grease that may have
accumulated on the cutter and moving parts. Scrape
off compacted dirt from the bottom of deck and then
wash surface thoroughly with a garden hose. A
coating of oil may also be applied to the lower deck
area to minimize oxidation.
2. Check blades and blade bolts for wear and replace if
necessary. See "Cutter Blade Maintenance" on
page 20.
3. Inspect for loose, damaged, or worn parts and adjust
or replace as needed.
4. Repaint parts where paint is worn or scratched to
prevent rust. Ask your Land Pride dealer for aerosol
touch-up paint. They are also available in touch-up
bottles with brush, quarts, and gallon sizes by adding
TU, QT, or GL to the end of the aerosol part number
10/11/17
Table of Contents
.
Part No.
821-011C
821-066C
821-070C
5. Replace all damaged or missing decals.
6. Lubricate as noted in "Lubrication Points" starting
on page 24.
7. Store cutter on a level surface in a clean, dry place.
Inside storage will reduce maintenance and make for
a longer cutter life.
8. Follow all unhooking instructions on page 18 when
disconnecting tractor from cutter.
Ordering Replacement Parts
Land Pride offers equipment in factory standard Beige
with black highlights. This implement is also available in
30904
Orange.
When ordering an optional color, the suffix number
corresponding to the color must be added at the end of
the part number. Parts ordered without the suffix number
will be supplied in factory standard colors.
82 . . . . . . . Orange
For example, if you are ordering a replacement part with
part number 555-555C and the existing part is orange,
then add the suffix 82 to the end of the number to make
the part number read 555-555C82.
Land Pride Touch-up Paint
Part Description
PAINT LP BEIGE SPRAY CAN
PAINT ORANGE SPRAY CAN
PAINT GP GLOSS BLACK SPRAY CAN
85 . . . . . . . Black
RCR1542 & RCR1548 Rotary Cutters 312-556M
23