Related Manuals for FlySky USM-GT3X
Summary of Contents for FlySky USM-GT3X
- Page 1 USM-GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM 用户手册 This product is suitable for 15 years old and above 本产品不适合15岁以下儿童使用...
- Page 2 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM 特殊标志 Special symbols Please pay attention to the following symbols when they appear in the manual and read carefully. 当以下标志出现在说明书的时候请注意并且仔细阅读。 Not following these instructions may expose the user to serious injuries or death. 如果使用者不按照说明方法操作，有可能导致使用者严重受伤，甚至致命的危险。 Not following these instructions may expose the user to serious injuries.
- Page 3 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Do not operate outdoors on rainy days, run through puddles of water or use when visibility is limited. Should any type of moisture (water or snow) enter any component of the system, erratic operation and loss of control may occur. 不要在户外雨天，有水的地方或当能见度有限的时候使用。...
- Page 4 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM System Characteristic 系统特征 This radio system works in the frequency range of 2.405 to 2.475GHz. This band has been divided into 142 independent channels. Each radio system uses 16 different channels and 160 different types of hopping algorithm.
- Page 5 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM TRANSMITTER Ch3 TRIM...
- Page 6 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM BACK ENTER(DOWN/UP) ST TRIM(RIGHT) ST TRIM(LEFT) TH TRIM(UP) TH TRIM(DOWN)
- Page 7 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Operation instruction 接收机操作说明 接收机与伺服器连接 Receiver and servo connections ON/OFF SWITCH 注意: 为保证良好的遥控距离,请将接收机天线与飞机机身垂直放置并远离金属物体。 Note: To ensure good remote control distance, please set the receiver’s antenna on the vehicle vertically and away from metal objects. Receiver 接收机...
- Page 8 Transmitter specifications: Number of channels: 3 Channel resolution: 1024 steps Power supply: 6V (1.5 V AA x 4) Low voltage warning: <4.2. Red LED will flash USM-GT3X 4.2-4.5V Red 4.6-5V Orange 5-6V Green <3.2 V Buzzer goes off to alarm 2.4 GHz type: AFHDS.
- Page 9 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM 对码 Binding The supplied transmitter and receiver are already bound at production time. If you are using another transmitter or receiver, you need to bind them before use : 1. Install batteries in the transmitter and turn it off. 2.
-
Page 10: Lcd Function Explanation
GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM LCD FUNCTION EXPLANATION LCD DISPLAY BUTTON FUNCTION: 按键定义: Turn the “ENTER” button counterclockwise: decrease the rate 左旋：逆时针旋转（做菜单选择及数据减）； Turn the “ENTER” button clockwise: increase the rate 右旋：顺时针旋转（做菜单选择及数据加）； Press “ENTER” button: select the menu 确认：确认按键（做菜单选择确定）； Press “BACK” button: return to the menu 返回：返回按键（菜单返回）；... - Page 11 “MODEL” menu. There are a total of 10 model memories from 0-9. Select the model by turning the “ENTER” button, then press the "ENTER" button to save and return to the menu screen. Press the “BACK” button and return to the initial menu at any condition. 功能说明： 此发射机（USM-GT3X）可存放10组模式（USM0-USM9）,每组都可以单独设定，以适应不同的机型。 参数说明： MODEL :机种编号（工厂预设定值为MODEL 1）； ACB：机种名称（工厂预设定值为USM）...
- Page 12 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM SUB-T Function: This function allows the user to sub trim the steering "ST", throttle "TH", or auxillary "AUX" channels. Parameter: CHANNEL: channel number, from ST channel to AUX channel 功能说明： 记忆微调功能可分别调节3个通道舵机的中位，当舵机调节不能满足需要时，该功能的调节作用就非常明显。工厂预设值 为00%; AUX 正负百分比（通道CH3微调）, 调整量为-100%--00%--100%,工厂预设值为00%。 the range of adjustment factory setting ST positive percentage...
- Page 13 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Function: This function reverses the operating direction of the channels: steering, throttle, and channel 3. Parameter: CHANNEL: channel number, ST, TH, AUX REV: reverse NOR: normal Operation: Press the "ENTER" button and turn to the “REV” menu. Press the “ENTER” button to enter the “REV”menu.
- Page 14 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM NAME Function: This function allows you to assign a user name (three characters) to each model memory. Parameter: MODEL NO: Model number. ”USM”: User name Operation: Press the “ENTER” button and turn to the “NAME” menu. Press the “ENTER” button to enter the “NAME”...
- Page 15 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM CRAW Function: This function allows the usage of 4 wheel steering for specifically for crawling or other vehicles that require mixing. Parameter: There are 4 different modes to control the composition of the direction. Model A: channel 1 control Model A direction.
- Page 16 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM TRIM Function: Use this function to adjust the neutral position of the steering, throttle and AUX channel. Parameter: CHANNEL: channel number, from ST to AUX ST. RBU: steering or 3rd channel right side , adjustment range: 00%--100% ( initial value is 00% ) ST.
- Page 17 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Function: while applying the brakes, locking them up can be easily done. which can cause your vehicle to spin out of control, this can be eliminated by pulsing the brakes, so that full control of your vehicle can be achieve at all times.
- Page 18 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Function: This function is used to change the sensitivity of the 2 channels around the neutral position. In order to “soften” or make aggressive the response, according to user 's demand. Parameter: CHANNEL: channel number, from ST and TH; 100%: steering “EXP”...
- Page 19 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Function: Use this function when performing left and right steering angle adjustments, throttle high side/brake side amount adjustment, and channel 3 servos up side/down side operation amount adjustment during linkage setup. Used to correct steering angle of adjusting left and right steering angles when there is a difference in the left and right turning radios.
- Page 20 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM Function: By setting the dual rates function, you can limit the total travel of each individual Channel. Parameter: CHANNEL: channel number, channel ST 100%:Dual Rate, when you want to increase the servo travel, turn the button to increase the rate. when you want to decrease the servo travel, turn the button to decrease the rate.0% is no signal output ,100% is maximum signal output.
-
Page 21: Fail Safe Function
GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM FAIL SAFE FUNCTION Function: Failsafe aims to prevent control loss during operation due to radio control signal loss between transmitter and receiver. If the receiver is not able to receive any signal from the transmitter, the throttle setting on the receiver will default back to its original setting. - Page 22 GT3X DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM 包装内容 Packaging content 3 channel 2.4G transmitter (USM-GT3X) 3 通2.4G发射机(USM-GT3X) 3 channel 2.4G receiver (FS-A3) 3 通2.4G接收机(FS-A3) User manual 说明书 FCC Statement 声明 FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules.
- Page 23 DIGITAL PROPORTIONAL RADIO CONTROL SYSTEM...