Electrical Requirements; Assembly Instructions; Assemble The Top Grille - Whirlpool SKT60 Series Installation Instructions Manual

J. Pan-Head Phillips Screw (7)
Part Number 3-24004-091
®†
L. Painted Pan-Head Torx Screw (4)
White Kit Part Number W10383593
Stainless Steel Kit
Part Number W10385275
1. Assemble the six top grille (B) sections by sliding one into the
other through the tongue and groove feature as shown.
†®TORX is a registered trademark of Saturn Fasteners, Inc.
4
K. Countersunk Phillips Screw (2)
Part Number 3-24004-159
M. Leveler Leg (4)
Part Number 3-82710-001

ASSEMBLY INSTRUCTIONS

Assemble the Top Grille

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your freezer or refrigerator into its final location,
it is important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your freezer be provided. Use an outlet that
cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, press and hold TEMP SETTING for
3 seconds to turn off cooling, and then disconnect the freezer or
refrigerator from the electrical source.
2. Attach the top trim notched grille (C) to those already
assembled by sliding it into the bottom/lowest grille section.