Rack Mount The Appliance - McAfee ATD-3000 Hardware Manual

Rack mount the appliance

To install the Advanced Threat Defense Appliance on the four-post 19-inch rack, use the rack-mounting kit. You
can use the kit with most industry-standard rack cabinets.
Task
For each mounting rail, use the following steps.
1
At the front of the rack, position the right or left mounting rail on the corresponding side so that the
a
mounting bracket aligns with the rack holes.
Figure 8 Slide rail installation
At the back of the rack, pull the back mounting-bracket (extending the mounting rail) so that it aligns with
b
the rack holes.
On each side of the rack, ensure that the mounting rails are the same level.
Figure 9 Install rail to rack
Clip the rail to the rack and secure it with the tie wraps.
c
12
Always load the rack from the bottom up. If you are installing multiple appliances, start with the lowest
available position.