SMC Networks SMC7724M/VSW Installation Manual page 22

A T
BOUT THE IGER
The switch also includes a DB-9 console port on the front panel for switch
configuration. When multiple units are stacked together, you can manage
the entire stack by connecting to the console port on the Master unit in the
stack. The push button on the front panel is used to select the Master unit
in the stack.
Notes: 1.
The switch also includes key system and port indicators that simplify
installation and network troubleshooting. The front panel has LEDs for
Ethernet link status/activity and Extended Ethernet link status, as well as
system status indicators.
The following figure shows the components of the EE Switch.
Expansion Slot
10/100BASE-TX, 100BASE-FX,
1000BASE-T,
1000BASE-X GBIC
Figure 1-2. SMC7724M/VSW EE Switch Front and Rear Panels
1-8
A E
CCESS XTENDED
Only one unit in the stack can act as Master.
If the stacking ports are connected, the SFP port is disabled.
2.
Stacking is not supported in the current firmware version.
3.
Stacking Master
modules
Status Indicator
Ethernet Interface Ethernet Interface
SFP Slot
E
THERNET
Ethernet Port
Stacking Master
Status Indicators
Push-button
VDSL Port
StatusIndicators
Stacking
On
Off
Master
Up Down
Stacking Ports
VDSL Connector (to Splitter)
VDSL
S
WITCH
System Status
Power Socket
Indicators
TigerAccess EE Switch TigerAccess EE Switch
7724M/VSW 7724M/VSW
Stacking
Power
Reset
Diag
Console
Reset Button
Console Port
Use this for console connections
100-240V~ 50-60Hz 1A 100-240V~ 50-60Hz 1A