Table of Contents
Advertisement
UG109
Rev 3.0, 25-Sep-2018
Button Descriptions
Read: Clicking on this button reads the ACT8865 registers and displays them in the GUI. Note that this reads
all registers. Active-Semi recommendsreading registers each time the ACT8865 powers-up to acquire the initial
register settings.Active-semi also recommends reading registers after making changes to them. Immediately
reading the registers after a write confirms the changes were properly stored.
Read Button
Write:Clicking on this button writes the GUI settings to the ACT8865's registers. All registers are written,
regardless of whether or not they were changed.
Write Button
Dongle Connection Status: The GUI also contains a dongle is connected status which indicates that Active-
Semi's USB-TO-I2C dongle is connected to the USB port of the driver installed. The figure below shows the two
possible indication status graphics.
Dongle connected
Dongle Disconnected
Innovative Power
TM
TM
is a trademark of Active-Semi.
ActiveSwitcher
17
Advertisement
Table of Contents
