Connections And System Setup; Pfd Unit Weights; Equipment Inspection And Handling - Vertiv Liebert PFD Installer/User Manual

3.2 Connections and System Setup

• Electrical service is required for all models. Electrical service must conform to national and local
electrical codes. See equipment nameplate for details.
• Plan the routing of wiring, piping and ductwork to the unit. Refer to the appropriate piping
connection location drawings, piping schematics, and electrical-connection drawings for your
system in .

3.3 PFD Unit Weights

3.4 Equipment Inspection and Handling

S I
AFETY NFORMATION
WARNING! Risk of improper moving, lifting, or handling of the unit. Can cause equipment
damage, injury or death. Read all of the following instructions and verify that all lifting and
moving equipment is rated for the weight of the unit before attempting to move, lift, remove
packaging from or prepare the unit for installation. Unit weights are specified in Table 3.2
above.
CAUTION: Risk of contact with sharp edges, splinters, and exposed fasteners. Can cause
injury. Only properly trained and qualified personnel wearing appropriate, OSHA-approved PPE
should attempt to move, lift, remove packaging from or prepare the unit for installation.
NOTICE
Risk of damage from forklift. Can cause unit damage. Keep tines of the forklift level and at a
height suitable to fit below the skid and/or unit to prevent exterior and/or underside damage.
When the unit arrives, inspect all items for any visible or concealed damage. Report any damage to the
carrier immediately and file a damage claim. Send a copy of the claim to your Vertiv representative.
If possible, maintain equipment and packaging until it is at the installation location.
10
Table 3.2 PFD Unit weights
Model #
PFD037A-L
PFD037A-H
PFD054A-L
PFD067A-L
PFD067A-H
PFDZ67A-L
Weight, lb (kg)
244 (111)
351 (159)
351 (159)
351 (159)
488 (222)
488 (222)
Vertiv | Liebert® PFD™ Installer/User Guide