Sennheiser Esfera SPM 8000 Instruction Manual page 17

Putting the SPM 8000 into operation
To remove the basket windshield:
Remove the "hairy" cover
the windshield.
Unscrew the rear part
Loosen the locking lever
Remove the front part
tol grip.
To attach the basket windshield:
Make sure that the microphone cable is guided correctly (see diagram on page 3).
Slide the front part
Screw the rear part
clock-wise.
Lock the windshield by pushing the locking lever
Replace the "hairy" cover
snap fasteners.
Inclining the SPM 8000
Loosen the locking lever 3, adjust the desired angle and tighten the locking lever
again.
Connecting the SPM 8000 to the SPB 8000/to audio devices
Connection data of the SPM 8000:
• 48 V ±4 V phantom power (P48, IEC 61938)
• XLR-5 connector or
• 2x XLR-3 connector via Y-adapter cable
To connect the SPM 8000 to a camera/audio device with
Connect the XLR-5 connector
To connect the SPM 8000 to the SPB 8000 central unit or to an audio device with 2 analog
XLR-3 inputs:
Connect the XLR-5 connector
Connect the two XLR-3 connectors of the Y-adapter cable
= left channel) to the inputs of the SPB 8000 central unit or of the audio device.
The inputs of the central unit are also marked red and yellow.
If you want to use the SPM 8000 digitally, you have to use an A/D converter.
6
by unfastening its snap fasteners and pulling it away from
8
of the windshield by turning it counter-clockwise.
2
by pushing it down.
7
of the windshield by pulling it away from the suspension/pis-
7
of the windshield over the shock-mount.
8
of the windshield to the front part of the windshield by turning it
6
by sliding it over the basket windshield and fastening its
4
of the SPM 8000 to the camera or audio device.
4
of the SPM 8000 to the Y-adapter cable
2
up.
XLR-5 input:
5
(red = right channel, yellow
3
5
(supplied).
SPM 8000 | 5