615.822.4392
Operating Instructions
DO NOT plug the heater into the wall socket until all assembly steps have been completed and make sure
that both switches are in the OFF position. UNIT MUST BE ON A DEDICATED ELECTRICAL
CIRCUIT
To adjust the IR telescopic body: Pull up on the release levers of the tightening clamps and adjust tension
using the tension knobs. Raise and lower the telescopic sections and/or swivel to desired position and then
push in clamp levers to secure. DO NOT over tighten tension knobs. There should only be a moderate
amount of tension to maintain the telescopic position of your heater.
1. Before turning on your Infrared Heating System, check to make sure the "On/Off" switch located
on the tilt switch (black box) of the head unit is pulled OUT or in the ON position (Note: to turn the
heater "Off", push in the switch). Next, make sure the "On/Off" switch located on pole is in "OFF"
position, and extend all 3 telescopic sections to their maximum extended length. Release clamp levers
and pull up on each of the sectional steel tubes until each tube stops. Then push in clamp levers to
secure sections in place. Adjust the tension knobs as needed to maintain height position.
2. The Infrared Heating System comes equipped with a heavy duty, 16/3 gauge wire and grounded plug.
This appliance must be used with an outlet that has been installed and grounded in accordance with
local codes and ordinances. DO NOT use an adapter with this product. Check with Liberty Party
Rental if the grounding instructions are not understood completely or if the wall outlet does not
match the plug. Make sure to turn the switch to "Off" and unplug the ground electrical cord when
the heater is not in use.
3. Plug in the appliance, turn the "On/Off" switch to "On" and enjoy the warmth!
Operating Tips
This appliance MUST be grounded.
* When using outdoors, we recommend using a certified GFI (Ground Fault Interrupt) outlet to
protect against electrical shock.
* All installations must be in accordance with I.E.E. safety regulations or the equivalent.
* Avoid the use of an extension cord with this appliance.
* Do not place any objects such as furniture, papers, clothing or curtains closer than 3 feet to the
front and sides of the heater.
Electric Radiant Heater
Operating Instructions & Trouble Shooting Guideline
*This unit is designed to be used on a single dedicated 20amp circuit.
Models: 02117/02678