SMC Networks Barricade SMC7004AWBR User Manual page 23

• Three RJ-45 ports for connection to a 10BASE-T/100BASE-TX
Ethernet Local Area Network (LAN). These ports can auto-
negotiate the operating speed to 10/100 Mbps, the mode to
half/full duplex, and the pin signals to MDI/MDI-X (i.e.,
allowing these ports to be connected to any network device
with straight-through cable). These ports can be connected
directly to a PC or to a server equipped with an Ethernet
network interface card, or to a networking device such as an
Ethernet hub or switch.
• One RJ-45 port for connection to an xDSL or Cable modem.
This port is fixed at 10 Mbps, full duplex. Use a Category 5
cable to connect this WAN port to a xDSL or Cable modem.
• One RS-232 serial port to connect to an ISDN Terminal Adapter
(TA) or to a PSTN analog modem.
• One parallel printer port that can be connected to a printer.
This printer can then be shared by any LAN/WLAN users.
• Two antennas (dipole, omni-directional).
I
NSTALLATION
2-3