Pairing The System - Dometic VT100DIG Installation And Operating Manual

Pairing the system

8 Pairing the system
I
NOTE
The transmitter module and the receiver module have to be paired with each other so
that the monitor can display the camera images. This is conducted at the factory.
8.1 Pairing the system manually with the pairing button
➤ Press the pairing button on the receiver module (fig. 7 2, page 5) three times within 10 s
(press the button approx. 1 time per second).
✓ The LED on the receiver module (fig. 7 3, page 5) flashes red.
✓ The monitor displays the message "Pairing Start" and a counter that counts down 50 s.
You need to perform the pairing of the transmitter module within 50 s.
➤ Press the pairing button on the transmitter module (fig. 6 2, page 5) three times within 10 s
(press the button approx. 1 time per second).
✓ The LED on the transmitter module (fig. 6 3, page 5) flashes red.
✓ The modules synchronise themselves with each other.
This takes approx. three to five seconds. For successful pairing, the monitor shows the "Save
data" message and the picture appears.
If pairing is unsuccessful, the monitor displays the message "Pairing Failed". Repeat
the pairing procedure.
8.2 Pairing the system with reverse gear
You can start pairing the module via the reverse gear if you connect the red cable from the trans-
mitter module to the positive terminal and the green cable of both modules on the reversing light.
➤ Switch on the monitor.
➤ Activate the required channel.
➤ Engage and disengage the reverse gear three times within 10 s.
✓ The LED on the transmitter module (fig. 6 3, page 5) and the LED on the receiver module
(fig. 7 3, page 5) flash red.
✓ The modules synchronise themselves with each other.
This takes approx. three to five seconds. For successful pairing, the monitor shows the "Save
data" message and the picture appears.
If pairing is unsuccessful, the monitor displays the message "Pairing Failed". Repeat
the pairing procedure.
16
VT100DIG
EN