Connecting Electrical Power To The Radio Link - Dometic VT100DIG Installation And Operating Manual

VT100DIG
I
NOTE
Pictures and sound are sent from the transmitter module to the receiver module. To
ensure flawless functioning, you need to check whether the wireless transmission is
stable before final installation.
To perform the installation, proceed as follows:
➤ Attach the modules temporarily to the planned installation location.
➤ Install the rear view video system if you have not already done so.
➤ Start up the rear view video system.
If the camera image transmission is stable (two or three reception bars at the top right of the
monitor), you can complete final installation of the two modules.
If faults occur (only one reception bar or a yellow warning triangle on the top right of the
monitor) turn or move the transmitter or receiver module slightly and conduct further tests.
Attaching the modules (fig. 8, page 6)
To do this, proceed as follows for each module:
➤ Hold the module at the chosen location and mark the four points for drill holes.
➤ Drill holes with a Ø of 4 mm at each of the points you just marked.
➤ Screw the module on with M5 x 20mm self-tapping screws.
Fixing the antennas (fig. 9, page 6)
I
NOTE
Always align the antennas in the same direction, for example, both vertically.
This improves the transmission performance.
➤ You can glue the antennae on the corresponding module.
7

Connecting electrical power to the radio link

7.1 General notes on laying cables
I
NOTE
• As far as possible, use original ducts for laying the cables, or other suitable options
such as panelling edges, ventilation grilles or dummy plugs. If no openings are avail-
able, you must drill holes for the cables. Check beforehand that there is sufficient
space on the other side for the drill head to emerge.
• Cables and connections that are not properly installed will cause malfunctions or
damage to components. Correct installation of cables and connections ensures
lasting and trouble-free operation of the retrofitted components.
EN
Connecting electrical power to the radio link
13