Disassembly Of Mix Pump - Stoelting 219 Owner's Manual

Mix pump
Table of Contents

Advertisement

CLEANING MIX LINES
The mix lines must be cleaned and sanitized whenever
changing mix or whenever the freezer is off for an
extended period of time – such as overnight, or nonbusiness
days. The mix lines are sufficiently cleaned and sanitized
when cleaning and sanitizing the pump and freezer as an
assembly.
Once every 2 weeks, if required, perform the following
steps:
A. Mix 2 gallons of milkstone remover solution according
to the directions on the container and pump through
the mix line.
B. Cut a piece of sponge slightly larger than the inside
diameter of the mix line. Place the sponge inside the
mix line and force through with tap water pressure. A
garden hose repair end clamped to the mix line works
well for this purpose.
3.6

DISASSEMBLY OF MIX PUMP

Refer to your Owner's Manual for detailed instructions on
proper freezer operation.
WARNING
THE MIX PUMP SWITCH MUST BE IN THE OFF
POSITION WHEN SERVICING OR CLEANING
PUMP.
A. Drain freezer according to freezer owner's manual.
CAUTION
NEVER DISCONNECT HOSES FROM FREEZER
OR PUMP WITHOUT FIRST OPENING SPIGOT
TO RELIEVE PRESSURE.
B. REMOTE MODEL: Loosen hose clamps and remove
tubing from pressure relief valve. Remove suction
tubing from pump and mix bag. Remove discharge
tubing from bottom of pump. Remove drive pin by
pulling straight out.
HOPPER MODEL: Remove liquid level indicator .
Remove the two wing nuts from the pressure switch
manifold retainer and remove the manifold (both
models).
C. Remove large hand nut (1), washers (2) and rear
hopper cover (3). (See Fig. 5)
1
2
LEVEL
INDICATOR
CYLINDER
TOP
Figure 5. Pump Assembly Removal
D. Remove quick connect (4) from manifold (5). Remove
two wing nuts (6), locking plate washer (7), and
manifold (5). Remove manifold connector O-ring (8)
from manifold (5), and manifold "O"-ring (9). Loosen
hose clamp (10) and remove hose (11). (See Fig.
6)
E. Remove two small hand nut(s) (12) and top lock plate
(13) from clamp rod (14). (See Fig. 7)
9
5
8
7
6
Figure
6. Manifold Disassembly
8
1
SUCTION CUP
1
REMOTE
MODEL
4
10
11
2
3

Advertisement

Table of Contents
loading

Table of Contents