Related Manuals for Aquatic CP6
Summary of Contents for Aquatic CP6
- Page 1 CP6 - WATERPROOF STEREO USER / INSTALLATION MANUAL AM/FM R A D I O TRIGGER 288W TRIGGERS AM/FM POWER R A D I O CHARGING PLEASE READ THIS INSTRUCTION MANUAL BEFORE INSTALLATION AND OPERATION...
-
Page 2: Table Of Contents
Table of Contents CP6 WATERPROOF STEREO 1 Getting Started................. 7 Audio & Settings Menus............1.1 Contents................7.1 Audio Menu................ 7.1.1 Beep Tone..............1.2 Connections............... 7.1.2 EQ................1.3 Connections Diagram............7.1.3 Loudness..............1.4 Power On................1.5 Installation................ 7.2 Setting Menu..............1.5.1 Mounting Hole Method 1.......... -
Page 3: Getting Started
Allows connection of the DAB+ Digital Radio Receiver (sold separately). 9. Bluetooth Antenna Allows a Bluetooth device to wirelessly connect to the unit. Aquatic AV does not recommend the Wired Remote Control WR6 for use in spa applications. *Retail packaged models only. www.aquaticav.com... -
Page 4: Connections Diagram
All open wire connections should be soldered and protected against water and dust for best long-term performance. Aquatic AV does not recommend the Wired Remote Control WR6 for use in spa applications. *Retail packaged models only. -
Page 5: Power On
In a spa application the red and yellow wires should be jumped together and then connected to the +12VDC output of the power source. In this set up the CP6 will always be on, with a very low current draw when idle. -
Page 6: Installation
2. Drill two pilot holes at the marked points and then using a circular saw drill two holes with a 3” (76.2mm) diameter. 3. The CP6 should fit through the widest points of the hole and then be secured using either of the two installaion methods listed below. -
Page 7: Installation Method 1
If the bracket needs to be shortened this can be done by removing the appropriate number of breakaway segments using a pair of pliars. 2. Review all outside surfaces of the CP6 stereo to ensure a proper water/dust seal. This is important for long-term environmental protection performance. -
Page 8: Installation Method 2
CP6 WATERPROOF STEREO 1.5.4 Installation Method 2 1. Remove the front trim ring from the CP6 stereo to reveal the four (4) front locking screws. 2. Slide the CP6 stereo through the mounting hole and secure the stereo using the front locking screws. -
Page 9: Controlling The Stereo
Controlling the Stereo CP6 WATERPROOF STEREO 2.1 Location of Controls 1. Preset 1 / Repeat Playback 7. 12V Triggers 2. Fast Rewind 8. Fast Forward 3. Audio/Menu 9. ESC/Preset 4. Mode button 10. Play/Pause 5. Rotary Selector 11. Preset 3 6. -
Page 10: Control Functions
Controlling the Stereo CP6 WATERPROOF STEREO 2.2 Control Functions Button Action AM/FM Audio/Menu Short Press Audio Menu: Bass - Treble - Balance - Fader - Beep - EQ - Loud Long Press Settings Menu: Dim H/L - PRI Info/Clk - P-Vol - Area US/Euro - Loc On/Off - Stereo/Mono -... -
Page 11: Wired Remote Control Wr6 (Sold Separately)
12V DC Trigger 1 Output On/Off Long Press 12V DC Trigger 2 Output On/Off Please note Aquatic AV does not recommend wired remote controls are used for spa or hot tub applications as use in such applications is not covered by warranty. www.aquaticav.com... -
Page 12: Listening Via Bluetooth
1. Enable Bluetooth Audio mode by pressing MODE and selecting Bluetooth. 2. Switch on your Bluetooth Audio device. 3. Select ‘CP6’ from the list of available devices to pair. No password should be required however if prompted for a password use ‘0000’. -
Page 13: Listening Via Usb
Listening via USB CP6 WATERPROOF STEREO 4.1 Listening via USB 1. Attach your USB thumb drive to the female USB connector. 2. If your USB device is readable then USB source mode will be automatically selected and your compatible content will begin to play. -
Page 14: Listening To Dab+ Digital Radio
CP6 WATERPROOF STEREO 5.1 What Is DAB+ Digital Radio? DAB+ Digital Radio provides access to hundreds of stations when used with Aquatic AV’s Digital Radio Receiver AQ-DAB+ (sold separately). DAB+ is only available within certain countries - please check your local network for more information. -
Page 15: Listening To Am/Fm Radio
Listening to AM/FM Radio CP6 WATERPROOF STEREO 6.1 Listening to AM/FM Radio 1. Enter radio mode by pressing MODE and selecting RADIO. 2. Navigate the available stations using the Fast Forward/Fast Rewind buttons. 3. Select the desired station by pressing the Rotary Selector button. -
Page 16: Audio & Settings Menus
7.1.2 EQ The CP6 stereo is equipped with an audio DSP (Digital Signal Processor) to provide preset listening experiences for different music types. If you have chosen a preset equalizer setting (Flat, Rock, Classic, or Pop) the previous Bass & Treble settings will be overridden. -
Page 17: Priority Display (Info/Clock)
Settings Operation CP6 WATERPROOF STEREO 7.2.2 Priority Display (Info/Clock) When set it to PRI INFO the display will by default show information relating to the music being played. Press and hold the MODE button to display the clock for 5 seconds. -
Page 18: Additional Features
If using two external trigger wires you can also activate the second external trigger by pressing and holding the 12V TRIGGER button to activate. Press and hold again to deactivate. Aquatic AV strongly recommend you speak to our technical service staff or your local Aquatic AV dealer if you are considering using this feature. -
Page 19: Specifications & Dimensions
Specifications & Dimensions CP6 WATERPROOF STEREO 9.1 Specifications Media Supported Media........Bluetooth Audio / USB / DAB+ / MP3 / AM / FM / AUX Device Charging........via rear USB cable (2.1A) Inputs Auxiliary..........1x stereo pair RCA Outputs Pre-Out.......... -
Page 20: Warranty Information
Some states do not allow limitations on the length of an implied warranty, so this limitation may not apply. No person is authorized to assume for Aquatic AV any other liability in connection with the sale of the product. How to obtain service You must obtain a return material authorization number (RMA) to return any product to Aquatic AV. - Page 21 FCC Statement CP6 WATERPROOF STEREO FCC ID: MADE IN CHINA FCC Statement to the User This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 22 Aquatic AV 282 Kinney Drive San Jose, CA 95112, USA E-mail: info@aquaticav.com US & Canada: 1 877 579 2782 International: +1 408 559 1668 Fax: +1 408 559 0125 www.aquaticav.com...