Page 1
For Machines of Manufacture post May 2002 Owners Manual If you are a tradesperson installing this unit, please leave this owners manual with the owner when you finish the installation. Thank You! Fiat Products LTD. 255 Hutchings Street Winnipeg, Manitoba R2X 2R4, Canada TEL. 204-633-6122 Service info.
Terms of this warranty are effective only when installation was made in compliance with the written installation instructions provided by FIAT. Residential steam generators used in a commercial application will void the warranty. DOC NO. 81009...
Page 3
Note: Failure to follow specific installation instructions will cause the warranty to be void. UNIT & SUPPLY LINES MUST BE PROTECTED FROM FREEZING!!! Vanity Closet Figure 1 Various options for the location of your Fiat steam Generator. DOC NO. 81009 3 OF 9 Rev A 10/03...
Page 4
4. Make the final connection and turn on water. All Fiat generators are equipped with an automatic water fill system. The water will stop after unit is filled.
Electrical Installation NOTE: All electrical wiring must be done per local electrical codes. Wire sizes recommended by National Electrical Code, Minimum wire temperature rating 90C. Generator Wire Gauge Breaker Size Model FSC 30 FSC 50 FSC 70 FSC 90 1. Turn off all electricity to the working area at the main breaker panel. 2.
Digital Control Installation Instructions 1. The digital control can be located inside or outside the shower area. Position the touch pad 4 to 6 feet from the floor inside or outside the steam room. Drill one 1-1/16” hole in the wall. 2.
Page 7
Digital Control Operation Instructions WARNING: Please consult your physician before using. If you are pregnant, elderly, have high blood pressure, diabetes, suffering from heart disease, intoxicated, or not in good health, do not use this steam bath. 1. Starting your steam bath. Press “STEAM” button to activate your steam bath session. 60 minute LED will light up, see figure 5.
Page 8
4. Setting memory. Find the desired time you want to set. Press and hold the “STEAM” button. LED will flash, continue to hold until light stops flashing and remains solid. Turn timer off by pressing “STEAM” button. Wait 15 seconds and restart your unit. Your desired time will illuminate, see figure 8.
Cleaning Instructions for Steam Unit (RECOMMENDED CLEANING SHOULD BE PREFORMED A MINIMUM OF TWICE A YEAR OR PER LOCAL WATER CONDITIONS.) Turn water supply off. Turn electricity breaker off. Remove drain plug to remove water from tank to floor drain or bucket. Reopen the water supply to flush unit for a few minutes.